CE测试项目2014

CE测试项目2014
常见频段与制式：
GSM 900/1800 ,WCDMA 2100/900
LTE Band 1/3/7/8/20 and etc.
BT:2.1+EDR+4.0
WIFI: 802.11 A/B/G/N 2.4G 5G DFS 频段
GPS 、NFC 等
RF 测试项目:
2G 部分 ETSI EN 301 511 / ETSI TS 151 010-1 参照标准 3GPP TS 51.010-1
ETSI EN 301 511 / ETSI TS 151 010-1
12.1.1 Conducted spurious emissions –MS allocated a channel
12.1.2 Conducted spurious emissions –MS in idle mode
12.2.1 Radiated spurious emissions– MS allocated a channel
12.2.2 Radiated spurious emissions –MS in idle mode
13.1 Frequency error and phase error
13.2 Frequency error under multipath and interference conditions
13.3 Transmitter output power and burst timing
13.4 Output RF spectrum
13.16.1 Frequency error and phase error in GPRS multislot configuration
13.16.2 Transmitter output power in GPRS multislot configuration
13.16.3 Output RF spectrum in GPRS multislot configuration
13.17.1 Frequency error and Modulation accuracy in EGPRS Configuration 13.17.2 Frequency error under multipath and interference conditions
13.17.3 EGPRS Transmitter output power
13.17.4 Output RF spectrum in EGPRS configuration
14.7.1 Blocking and spurious response - speech channels
14.18.5 Blocking and spurious response
3G 部分ETSI EN 301 908-1 / ETSI EN 301 908-2 参照标准3GPP TS 34.121-1
ETSI EN 301 908-1
4.2.2 Radiated emissions (UE) 参照 301 980-1
4.2.4 Control and monitoring functions (UE) 参照301 908-1
ETSI EN 301 908-2 参照标准 3GPP TS 34.121-1
5.2 Maximum Output Power
5.2A Maximum Output Power with HS-DPCCH (Release 5 only)
5.2B Maximum Output Power with HS-DPCCH and E-DCH
5.4.3 Minimum Output Power
5.4.4 Out-of-synchronisation handling of output power
5.9 Spectrum emission mask
5.9A Spectrum Emission Mask with HS-DPCCH
M O R L A
B
5.9B Spectrum Emission Mask with E-DCH
5.10 Adjacent Channel Leakage Power Ratio (ACLR)
5.10A Adjacent Channel Leakage Power Ratio (ACLR) with HS-DPCCH
5.10B Adjacent Channel Leakage Power Ratio (ACLR) with E-DCH
5.11 Spurious Emissions
6.4 Adjacent Channel Selectivity (ACS) (Rel-99 and Rel-4)
6.4A Adjacent Channel Selectivity (ACS) (Rel-5 and later releases)
6.5 Blocking Characteristics
6.6 Spurious Response
6.7 Intermodulation Characteristics
6.8 Spurious Emissions
4G 部分 ETSI EN 301 908-1 / ETSI EN 301 908-13 参照标准3GPP TS 36.521-1
ETSI EN 301 908-1
4.2.2 Radiated emissions (UE) 参照 301 980-1
4.2.4 Control and monitoring functions (UE) 参照301 908-1
ETSI EN 301 908-13 参照标准 3GPP TS 36.521-1
6.2.2 UE Maximum Output Power
6.3.2 Minimum Output Power
6.6.2.1 Spectrum Emission Mask
6.6.2.3 Adjacent Channel Leakage power Ratio
6.6.3.1 Transmitter Spurious emissions
7.5 Adjacent Channel Selectivity (ACS)
7.6.1 Blocking characteristics -In-band blocking
7.6.2 Blocking characteristics -Out-of-band blocking
7.6.3 Blocking characteristics -Narrow band blocking
7.7 Spurious response 7.8 Intermodulation characteristics
7.9 Spurious emissions
BT 部分 ETSI EN 300 328 1.8.1/ ETSI EN 300 328 1.7.1
ETSI EN 300 328 1.8.1
4.3.1.1 RF output power
4.3.1.2 Duty Cycle, Tx-sequence, Tx-gap
4.3.1.3 Dwell time, Minimum Frequency Occupation and Hopping Sequence
4.3.1.4 Hopping Frequency Separation
4.3.1.5 Medium Utilisation (MU) factor
4.3.1.6 Adaptivity (Adaptive Frequency Hopping)
4.3.1.7 Occupied Channel Bandwidth
4.3.1.8 Transmitter unwanted emissions in the out-of-band domain M O R L A B
4.3.1.9 Transmitter unwanted emissions in the spurious domain
4.3.1.10 Receiver spurious emissions
4.3.1.11 Receiver Blocking
ETSI EN 300 328 1.7.1
4.3.2 Maximum e.i.r.p. spectral density
4.3.3 Frequency range
4.3.4 Frequency hopping requirements
4.3.5 Medium access protocol
4.3.6 Transmitter spurious emissions
4.3.7 Receiver spurious emissions
WIFI 2.4G 部分 ETSI EN 300 328 1.8.1/ ETSI EN 300 328 1.7.1 ETSI EN 300 328 1.8.1
4.3.2.1 RF output power
4.3.2.2 Power Spectral Density
4.3.2.3 Duty Cycle, Tx-sequence, Tx-gap
4.3.2.4 Medium Utilisation (MU) factor
4.3.2.5 Adaptivity (adaptive equipment using modulations other than FHSS)
4.3.2.6 Occupied Channel Bandwidth
4.3.2.7 Transmitter unwanted emissions in the out-of-band domain
4.3.2.8 Transmitter unwanted emissions in the spurious domain
4.3.2.9 Receiver spurious emissions
4.3.2.10 Receiver Blocking
ETSI EN 300 328 1.7.1
4.3.2 Maximum e.i.r.p. spectral density
4.3.3 Frequency range
4.3.4 Frequency hopping requirements
4.3.5 Medium access protocol
4.3.6 Transmitter spurious emissions
4.3.7 Receiver spurious emissions
WIFI 5G 部分 ETSI EN 300 440-1 / ETSI EN 300 440-2 /
针对频段 5.8GHz ISM Band 5725-5875 4.2.1.1 Equivalent isotropically radiated power
4.2.1.2 Permitted range of operating frequencies
4.2.1.3 Unwanted emissions in the spurious domain
4.2.2.1 Adjacent channel selectivity
4.2.2.2 Blocking or desensitization
4.2.2.3 Spurious radiations
M O R L A
B
WIFI 5G 部分 ETSI EN 301 893
针对频段 5GHz Band 5150-5725
4.2 Centre frequencies
4.3 Nominal Channel Bandwidth
4.4 RF output power
4.5.1 Transmitter spurious emissions
4.5.2 Transmitter unwanted emissions
4.6 Receiver spurious emissions
4.8 Medium Access Protocol
WIFI 5G 部分 ETSI EN 301 893
针对频段 5GHz DFS Band 5250-5350, 5470-5725
Channel Availability Check
Off-Channel CAC
In-Service Monitoring
Channel Shutdown
Non-Occupancy Period
Uniform Spreading
GPS 部分 ETSI EN 300 440-1 / ETSI EN 300 440-2
针对频段 1575.42MHz
5.4.3 Receiver spurious emissions
NFC 部分 ETSI EN 300 330-1 / ETSI EN 300 330-2
针对NFC 频段 13.56MHz
5.2.1.1 Permitted range of operating frequencies
5.2.1.2 Limits for the permitted range of modulation bandwidth
5.2.1.3 Emission limits for transmitters in the range from 9kHz to 30MHz
5.2.1.4 Transmitter spurious and out-of-band emissions 5.2.2.1 Adjacent channels selectivity – in band (receiver category 1 only)
5.2.2.2 Blocking or desensizitation (receiver categories 1 or 2 only)
5.2.2.3 Receiver spurious emissions
EMC 部分ETSI EN 301 489-1/ ETSI EN 301 489-3/ ETSI EN 301 489-7 ETSI EN 301 489-17/ ETSI EN 301 489-24
测试方法参照 EN 55022 EN61000等
Radiated emission
Conducted emission, AC ports
Conducted emission, DC ports
Conducted emission, Telecom ports
Harmonic current emissions
Voltage fluctuations & flicker
Electrostatic discharge immunity M O R L A B
Radiated RF electromagnetic field immunity
Electrical fast transient/burst immunity
Surge immunity, AC ports, Telecom ports
Immunity to conducted disturbances induced by RF fields Voltage dips and short interruptions immunity
SAR 部分 EN50360:2001 /EN 50566:2013/EN 62209-1:2006 EN62209-2:2010/EN62479:2010
Left Head SAR
Right Head SAR
Body SAR
SAFTY 部分 EN60950-1:2006+A11:2009+A1:2010+A12:2011 Input Test
Heating Test
Battery Charger Tests
Battery Discharger Tests
Battery Abnormal Tests
Varbration Motor BlockedTest
Speaker Short Test
Durability of Marking Test
Maximum sound 部分 EN 50332-1:2000 /EN 50332-2:2003 Maximum sound pressure level
Maximum output voltage Vm Wideband characteristics voltage M O R L A B。