Greenfield

Greenfield POLYMERS

LIMITED

MYLESTONE HOUSE, SOWERBY NEW ROAD, SOWERBY BRIDGE,

WEST YORKS. HX6 1AA

TEL: + 44 (0) 1422 835835 FAX: + 44 (0)1422 839439

E-mail:admin@

FLUSHING AGENTS / SOLVENTS DESCRIPTION– Greenfield Polymers Ltd supply a comprehensive range of flushing agents / solvent cleaners (please refer to the information below to find the most suitable product).

PC 5040 Flushing agent – this product is an inert compound which does not react with either the Base / Resin or Activator / Hardener compound. It is ideal for flushing two component mixing machines of material prior to periods of shut down and is also suitable when cleaning machines of uncured material. It has no effect on either cured material or crystals caused by the reaction of Isocyanate with moisture.

PC 5025 Solvent Flushing agent – this product is low hazard, non-flammable solvent which is used for flushing machines and for removing either uncured Base or Activator component from the machine or work surface. Pc 5025 Solvent tends not to interfere with rubber and plastic parts of a machine (please refer to the machine manufacturer for suitability) however is not really suited for removing either cured material or solid blockages such as moisture reacted Isocyanate crystals.

PC 5982 Greenstrip – this product is non-flammable, non-chlorinated, non-carcinogenic, non-ozone depleting designed to replace methylene chloride, MEK, acetone and 1,1,1,-tricloroethane, which has proven highly suitable for the removal of cured and curing polyurethane. Representing a technical breakthrough green strip has the same, if not better cleaning power as PC 2712 solvent without the hazards associated. It has been proven to also remove cured resin.

PC 2712 Solvent– this product has been chosen for its ability to remove uncured material from machines / work surfaces. In some cases it will also remove / dissolve cured material and Isocyanate crystals dependent on the period left in saturation. It is also widely used as a dynamic head-fluching agent in two component mixing machines. Please note that when used through machine parts such as rubber and plastic these may be affected due to its aggressive nature. PC 2712 should not be used to clean Isocyanate spills (Please refer to information on Decontam and spills kits).

The above data / information refers to typical laboratory test results. Full Health and Safety and manufacturing specifications are available on request. The application use and processnig of our products is the responsibility of the user. The technical or other advice, information or data provided by us whether verbally, in writing or by way of trials is given without guarantee or warranty. When using flushing agents and Solvents users are requested to seek advice from the Equipment supplier for suitability.