WL08资料

WL08 800 560 800
WL10 1000 700 1000
UNIT
Volts Volts Volts Amps. Amps. A2 S Volts µA mA pf °C/W °C °C
Notes :
1 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2 ) Thermal resistance from Junction to Ambient at 0.375" (9.5 mm) lead length P.C. Board mounting.
1.10 (27.9) MIN.
+
AC
1.00 (25.4) MIN.
0.034 (0.86) 0.028 (0.71)
AC
AC
MECHANICAL DATA :
* Case : Reliable low cost construction utilizing molded plastic technique * Epoxy : UL94V-O rate flame retardant * Terminals : Plated leads solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Polarity symbols marked on case * Mounting position : Any * Weight : 1.29 grams
UPDATE : APRIL 23,1998
元器件交易网www.cecb2b.com
RATING AND CHARACTERISTIC CURVES ( WL005 - WL10 )
FIG.1 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT
1.0 30
PC Board
0.22 (5.59) 0.18 (4.57)
+
0.22 (5.59) 0.18 (4.57)
Dimension in inches and (millimeter)
MAXIMUM RAபைடு நூலகம்INGS AND ELECTRICAL CHARACTERISTICS
RATING
Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Current 0.375" (9.5 mm) lead length Tc = 50°C Peak Forward Surge Current Single half sine wave Superimposed on rated load (JEDEC Method) Rating for fusing ( t < 8.3 ms. ) Maximum Forward Voltage per Diode at I F = 1.0 Amp. Maximum DC Reverse Current Ta = 25 °C at Rated DC Blocking Voltage Ta = 100 °C Typical Junction Capacitance per Diode (Note 1) Typical Thermal Resistance (Note 2) Operating Junction Temperature Range Storage Temperature Range
FIG.2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT
AVERAGE FORWARD OUTPUT CURRENT, AMPERES
0.8
PEAK FORWARD SURGE CURRENT, AMPERES
0.375
24
T J = 55 ° C
元器件交易网www.cecb2b.com
WL005 - WL10
PRV : 50 - 1000 Volts Io : 1.0 Ampere
SILICON BRIDGE RECTIFIERS WOB
0.39 (10.0) 0.31 (7.87) 0.22 (5.59) 0.18 (4.57)
FEATURES :
SYMBOL WL005 WL01 WL02 WL04 WL06
VRRM VRMS VDC IF(AV) IFSM I 2t VF IR IR(H) CJ RθJA TJ TSTG 50 35 50 100 70 100 200 140 200 400 280 400 1.0 30 10 1.2 10 1.0 24 36 - 50 to + 150 - 50 to + 150 600 420 600
6
0
1
2
4
6
10
20
40
60
100
CASE TEMPERATURE, ( °C)
NUMBER OF CYCLES AT 60Hz
FIG.3 - TYPICAL FORWARD CHARACTERISTICS REVERSE CURRENT, MICROAMPERES
20 10
FIG.4 - TYPICAL REVERSE CHARACTERISTICS
* * * * * * High case dielectric strength High surge current capability High reliability Low reverse current Low forward voltage drop Ideal for printed circuit board
FORWARD CURRENT, AMPERES
10
T J = 100 °C
1 TJ = 25 ° C 0.1 Pulse Width = 300 µs 1 % Duty Cycle
1.0
0.1
T J = 25 °C
0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8
0.01 0 20 40 60 80 100 120 140
Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%.
0.6
Copper Pads 0.22" x 0.22" (5.5 x5.5mm)
18
0.4
12 SINGLE HALF SINE WAVE (JEDEC METHOD)
0.2 60 Hz, Resistive or Inductive load. 0 0 25 50 75 100 125 150 175
FORWARD VOLTAGE, VOLTS
PERCENT OF RATED REVERSE VOLTAGE, (%)