氯化橡胶厚浆型面漆的使用说明

Storageand Handling 贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处
Pack size 包装规格 25Kg in 20 liter container 25公斤装于20公升容器中Flash Point 闪点 38℃
Specific Gravity 比重Approx12-1.35Kg/L 大约1.2-1.35公斤/公升
Intended Uses
用途适用于船舶、集装箱、户外各种钢结构及混凝土设施等的防腐，机械性能优良，并具有较好的耐候性，封闭性和防潮性、漆膜坚韧。

Suited for anti-corrosive protection of vessel、cargo container, all kinds of outdoor steel, and iron structure and concretes falicities etc, It has excellent mechanical performance and good resistance to weather and humidity sealing and tough film
Product Information 产品简介多种颜色，厚膜型Many colors. High build
Application details 产品数据V olume Solids 固体份≥43%
Dry Flm Thickness干膜厚度
80 microns equivalent to180 microns of wet film
80微米相当于180微米湿膜厚
Theoretical Coverage 理论涂布率 4.63-4.12m2 /Kg 4.63-4.12平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗
Storage and Handling 施工详述Mix Radio 混合比One pack 单罐装
Method of Application 施工方法
Airless Spray 无空气喷涂 Recommended 推荐采用
Brush or Roller 涂刷或辊涂 Recommended 推荐采用
Conwentional Spray 传统喷涂 Not Recommended 不推荐使用
Thinner 稀释剂 SC001
Cleaner 油漆设备清洗剂 SC001
Pot Life 使用期 Not limit 不限制
Storage 贮存期 One year 一年
Drying time
干燥时间
Substrate
Temperature
底材温度
Touch Dry
表干
（h）
Hard Dry
硬干
(h）
Over coating Interval
覆涂间隔
Min最短Max最长
25℃0.5-1 12-24
0℃ 24 hours 小
20℃ 8 hours 小时
30℃ 6 hours 小时
Not limit
不限氯化橡胶厚浆型面漆的使用说明
Specification and Surface preparation 技术要求及表面处理Steel Surface to be painted should be shot or grit blassted Standard Sa2.5 or rust-removed manually with power tool to Swedard St3.
施工钢材表面需经抛丸或喷砂处理除锈达瑞典标准Sa2.5级或手工、动力除锈达St3.
Limitations
限制Preceding Coat: Epoxy micaceous iron oxide anti-corrosive paint; Chlorinated rubber aluminium dust anti-corrosive paint. High build cholorinated rubber iron red anti-corrosive paint. Chlorinated rubber micaceous iron oxide anti-corrosive paint, Epoxy glass flake anti-corrosive paint etc.
前道配套涂料：环氧云铁防锈漆、氯化橡胶铝粉防锈漆、氯化橡胶铝粉厚浆型防锈漆、氯化橡胶铁红厚浆型防锈漆，氯化橡胶云铁防锈漆、环氧玻璃鳞片防锈漆。

Safety Precautions 安全措施This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
This product is a kind of solvent-based paint .Inorder to avoid danger or accident, minimal safety precautions,as follow , should be down .
The paint contains volatile solvent and is flammable . So must keep away from sparks and open flames.No smoking at applacation site ,Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid producting sparks .Flash point of paint , mentioned above on product Data sheet, is the lowest temperature at which mixture of the volatile materails of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general, Therefore, 200m3 of ventilation quantuty per 1Kg solvent (according to the solvent ) is necessary.
Product skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves,eye protection, face masks barrier cream and so on ). Kif paint gets in touch with skin , wass fully with large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination. NOTICE: If consumers have not taken effective safety precautions(Refer to the specfications), our company will NOTbe responsible for any accident.
本产品由专业人缘在工业场所使用,使用时请参照本说明书及健康安全手册,如客户在使用本产品前,未能仔细了解有关产品的健康安全知识,请与本公司联系.
该涂料为溶剂型涂料,为避免事故或危险发生,应采取最低限度的安全措施如下:
此涂料为易燃物,并含有挥发性易燃溶剂,,故必须远离火星和明火,严禁在作业场所吸烟,并采取有效措施,防止火星产生(如采用防爆电器设备,杜绝静电积累,避免金属撞击等)本产品说明书中所列涂料及溶剂的闪点是引起燃烧的最低温度. 施工场所应尽量进行通风良好,为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10%,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10%的工作环境.
采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服,手套,护目镜,面罩及涂防护油等)如产品不慎接触到皮肤,应用温水及肥皂或适当的工业清洁剂彻底清洗,如眼睛受到污染,用清水冲洗至少10分钟,并立即就医.
建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,尤其在通风不良环境下施工时,细心处理旧漆桶以免污染环境.
责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任. 来源。