防潮箱说明书

ANDBON TM
Damp Proof Cabinet Instruction Manual
防潮箱使用手册
珠海安德宝科技有限公司
ZHUHAI ANDEBAO TECHNOLOGY
CO.,LTD
一、产品特点：
1.防潮箱采用了当今世界上最新特殊材料进行冷凝原理除湿，具有除湿快，1—3小时即除湿生效，且达超低湿RH25%—50%。

无需空箱预置运行，通电即可吸湿，控制旋钮调节，恒湿精确无故障。

2.特制除湿模块、无压缩机、无风扇、安静无噪声、无热效应、柜内RH值均匀。

3.柜体采用直流电输入，耗电小，节能环保，无漏电危险，使储存物免受高压产生漏电及火灾潜在的危险。

4.具有防潮、防蛀、防霉、防锈、防变质、防尘等储存功能，是保存物品成本最低的一种储藏方式。

二、适用参数
三、性能说明：
1.湿度传感器精度﹤8%RH测量范围10—
99%RH
2.环境温度0—50℃
3.仪表响应速度快，浸水或结露后迅速恢复。

4.全互性，受温度影响小，长期稳定性和可靠性好，是目前最先进的一种控制仪。

四、使用指导
1.安置平稳柜体，柜背离墙、物体5—10cm左右。

根据要求调整放好可调节脚与层板。

2.如图1，电源隐藏的机种只要把AC插头插上即可。

如图2—1，将整流电源插头插入可同时把储存物放置防潮柜中。

3.开机后，调节储存物最佳恒湿值（参考常用参数表达式），这时柜内机芯设备即开始工作，将柜内的湿度逐渐排出。

4.经2—3小时左右通过湿度表观察湿度已稳定保持在恒湿值范围。

图1 机身外观部件示意图
显示表
板
除湿机芯
插头
图2-1 除湿心藏外观（背面）供电示意图
丝
直流插座
电子开关电源
直流转换插座
（AC100V-260V）
（DC5V）
五、旋钮调控说明：
1.启动调节旋钮由E旋A位，为低湿至高湿（旋转时绿色指示灯最亮为低湿，灯暗为高湿）。

2.经3小时运行，湿度指示表通常会出现比你所需湿度低，
等湿度回升。

3.湿度调控旋钮的湿度标志数据为空载时的参数，由于储存物的湿度各有差异会出现与湿度指示表有偏差，所以在储物除湿时，该数据为相对湿度，此时，应以湿度指示表为准，进行旋钮调整到你所需的湿度值。

4.请根据你所存放物品参照“保存湿度参数”进行操作调湿。

5.调至你所需湿度后，如储存物没改变可不用再调湿。

电源指示灯
湿度
调节旋钮
LED显示操作说明
1.如图3，显示：用数位LED显示，显示实测相对湿度值，发光二极管（OUT）指示除湿输出状态。

2.按键：数据设置（SET）键，增加和减少键，用于设置相关参数。

3.目标湿度设置键，屏闪的数字即为目标湿度，按增减键修改。

4.按增减键，显示恒温目标，3秒钟后自动恢复恒温值。

5.关、停电有记忆，保存原来的设定值，免重新参数调整。

工作指示灯
地址：广东省珠海市香洲区山星工业城110栋
网站：
ANDBON TM
Damp Proof Cabinet
Instruction Manual
ZHUHAI ANDEBAO TECHNOLOGY CO.,LTD Product characteristics
1.This product has adopted the latest cooling sets of principles in the
world, clear the moisture fast, it will force between 1-2 hours. It also can achieve the lowest moisture 25%-50%RH. Without the air cabinet to work, it can absorb moisture with the electrical, the
controller will adjust automatically, constant damp accurate and has no obstacles.
2.Clear the moisture has patent, machine chip has no compressor, no
fan, no noise, no hot effect, the RH value in cabinet is even.
3.The cabinet has adopted direct electricity, has no electrical
dangerous and can avoid the object of the goods from firing,
power and energy.
4.The product has no moisture, is good at preventing the moth,
preventing mildew, preventing rusting, preventing bad, preventing dust in storing function. It is a way to store things which has
lowest cost.
Optimal Preservation Parameter
Performance shows
1.The h umidity sensors’ precision is small than 8% RH, the
measurement ranges of 10 - 99% RH.
2.Environmental temperature ranges 0—50 ℃
3.The h umidity sensors’ speed is fast, it will rapid recovery in water
or a condensation.
4.Control apparatus is affected by temperature yet and the long-term
stability and reliability, is the most advanced of the control
apparatus.
The using guide
First, resettle the body of cabinet smoothly, put the back of cabinet off the wall about 5-10cm. According to the demand to adjust the right foot with the board.
Second, as in figure 1, the hidden machine just put the AC plug in. As in figure 2-1, put this electrical plugs in also can place the object of the goods from moisture cabinet.
Third, after opening the machine, adjust the storing things to be best value for a constant. (Reference the often used of parameter
expression), then the internal cabinet of the machine chip will start working, drain the humidity of the internal cabinet gradually.
Fourth, after two or three hours by watching moisture, it has kept a best value for a constant. Microcomputer Meter Drawer Tray Power Cord Lock and handle Dehumidification Clock mechanism
DC Input
The instructions of the button 1. Open to adjust the button from E to A, is from low wet to high wet
(The green sign bright is low wet ， or that is high wet).
2. After working 3 hours, the wet instructions watch will display
lower wet that you need, than you must to adjust the green sign clockwise to wait high wet.
3. The button sign data are unloaded items, the storage things ’ wet
is different, so the wet instructions watch will different. The data is relative humidity when you removing the wet of storage
things. Now, you should to adjust the wet you need according
the wet instructions watch.
4. According your storage things, reference items preserve moisture parameter to adjust wet.
5. Adjust the wet that you need, if the storage things have no
change, you needn ’t to adjust. Radiator
Evaporation
Condensation board
Semi-conductor
Outside of the cabinet
Moisture
Cooling
Condensation
Humidity Meter made in Germany Activation Indicator
Power Indicator。