华为2352版本命令

<soho2352-3#> sys
Enter system view, return user view with Ctrl+Z.
[soho2352-3#] int ether 0/0/2
[soho2352-3#-Ethernet0/0/2]?
ethernet-l2 interface view commands:
bpdu BPDU message
broadcast-suppression Set broadcast flow suppression
carrier Set carrier function
cfm Connectivity fault management, which is defined in the
dhcp Dynamic host configure protocol
display display
dot1x 802.1x configuration information
duplex Configure duplex operation mode
* no decompiling or reverse-engineering shall be allowed. *
* Notice: *
* This is a private communication system. *
port-isolate port-isolate
port-mirroring Mirror port
port-security port security
protocol-vlan Current hybrid port's protocol-based VLAN
dhcpv6 Dynamic host configure protocol
display Display current system information
***********************************************************
* All rights reserved (2005-2008) *
* Without the owner's prior written consent, *
[HBN-2352-1-Ethernet0/0/2]
Login authentication
Password:
Info: The max number of VTY users is 5, and the number
of current VTY users on line is 1.
lldp Link Layer Discovery Protocol
loopback-detect Loopback detect function
loopbacktest Configure port loopback test
als set automatic laser shutdown
am port isolate
arp Specify ARP configuration information
qinq QinQ port
qos QoS configuration
quit Exit from current command view
reset Reset Reboot information
arp-limit Limit the number of learnt ARP
arp-miss Specify ARP MISS configuration information
auto Auto negotiates port mode
tracert Trace route function
traffic-policy Apply specific traffic policy
traffic-pppoe Configure pppoe
trust Specify trust parameters
802.1ag
dei Specify dei as drop precedence
description S
dhcp Dynamic host configure protocol
efm EFM Configuration
enable Enable function
eth-trunk Add the interface into eth-trunk
flow-control Configure flow-control operation mode
restart Restart the specified interface
return Exit to user view
rmon Specify RMON
rmon-statistics Specify RMON-Statistics
mac-address MAC address
mac-authen MAC authenticate configure information
mac-forced-forwarding Mac-Forced Forwarding
mac-table MAC address learned by software
set set operation
shutdown Shutdown the specified interface
smart-link Smart link configuration information
ip-subnet-vlan Vlan assignment based on ip subnet
jumboframe Configure port jumboframe
lacp Link aggregation control protocol
* Unauthorized access or use may lead to prosecution. *
***********************************************************
Login authentication
Password:
mac-vlan Mac-based vlan
mdi set mdi
multicast-suppression Set multicast suppression
ndp Neighbor discovery protocol
negotiation set negotiation mode
ntdp Network topology discovery protocol
ping Ping function
port Swith port
icmp Specify ICMP configuration information
igmp-proxy Specify parameters for IGMP-Proxy
igmp-snooping Specify parameters for IGMP-Snooping
undo Cancel the setting
unicast-suppression Set unknown unicast suppression
vlan Set VLAN precedence
voice-vlan Voice VLAN
speed Configure port speed mode
statistic Security statistic config
storm-control storm control
stp Spanning tree protocol
bpdu BPDU message
bpdu-tunnel bpdu-tunnel
broadcast-suppression Set broadcast suppression
description Specify interface description
Note: The max number of VTY users is 5, and the current number
of VTY users on line is 1.
<HBN-2352-1> sys
Enter system view, return user view with Ctrl+Z.
[HBN-2352-1] int ether 0/0/2
[HBN-2352-1-Ethernet0/0/2] ?
Ethernet interface view commands:
am Port isolate
auto Auto negotiates port speed mode