JUKI机的错误代码

JUKI机的错误代码
E250001
Emergenoy stop switch has been pressed
已按下紧急停止开关。

E25OO2
Gopy pneumatic pressure has dropped Do you ignoreit？
气动压力有所下降。

Will return to Home position
是否回原点。

Z2020
Return to Home position is not finished yet
返回到初始位置尚未完成。

E007001
Origin retrieval has not yet been completed
原产地检索尚未完成。

W210001
Remove nozzle and returnit to the previous position on ATC
删除吸嘴，并回到先前的ATC位置上.
E200092
Origin retriexal is interrupted since error has occurrd when checking nozzle during origin retrieval
Turn OFF the power to the machine and perfom inspecton
原产地检索中断已经发生错误，请关闭电源检查吸嘴对机器执行检查。

E004219
Return to home has not yet been completed
返回首页尚未完成。

E004225
MTC is disable
MTC 是禁用的。

Q004301
Rxit machine setup Set value is aved
退出机器的设置保存设定值。

E006049
It failed to the centering by laser lode；98。

75 confirm pick position or comonent data 〈outcine caser position，Algorithmetc>
激光代码中心失败，98.75 确认跳位置或组件的数据《大纲合适位置算法〉E24013
Noozle attaching proccess error the process has been carrid out theugh nozzle has been already set in positon.
吸嘴连接过程中出现错误，这个过程已经走出设置位置.
E240013
Nozzle attatachin process error the process has been carred out though nozzle has been alredy setin position
吸嘴连接过程中出现错误，虽然吸嘴已经到了百分之位置
Q004304
Error has occurred during nozzle more to parking possition?
错误发生在吸嘴的附件移动停车位置
E202293
Orrgin retrieval is interrupted since errof of right head lassr has occurred when checking nozzle during origh retrieval tum OFF the power to the machine and perform inspection
产地与右激光头中断期间发生错误检索
解决方法;拿棉签清洁镭射激光头
E251246
Z axis of righe head LM628 alarmcposition error turn OFF the power to the machiie and perform inspection
头部位置误差LMG28 报警请关闭电源检查执行和机器
W0309
File exists orerurite?
文件存在覆盖？。