喜来登酒店工程部工作手册英文版)

STANDARDS AND PROCEDURES

DEPARTMENT: JOB CATEGORY:

REPAIRS AND MAINT. KEN-FIX-IT/HANDYMAN

HEAD: CHIEF ENGINEER G..M. APPROV AL: DATE:

TASK: BATH REPAIRS

STANDARD: REPAIR BA TH CHIPS AND SCRA TCHES IN A PROFESSIONAL MANNER

======================================================================

PROCEDURE:

When repairing baths, only “Bath Repair Kits”are to be used. Mix and apply as per the instructions on the back side of the packet.

NOTE: PAINT IS NOT TO BE USED UNDER ANY CIRCUMSTANCES.

STANDARDS AND PROCEDURES

DEPARTMENT: JOB CATEGORY:

REPAIRS AND MAINT. KEN-FIX-IT/HANDYMAN

HEAD: CHIEF ENGINEER G.M. APPROV AL: DATE:

TASK: SERVICING A ROOM AIR CONDITIONER

STANDARD: SERVICE AIR CONDITIONER AS PER THE PROCEDURE ON EACH KEN-FIX-IT VISIT

======================================================================

PROCEDURE:

1.Switch air conditioner on and check all four locations on the switch. Operate the fan correctly

(i. e. off, low, medium and high).

2.Operate the thermostat and check the cooling valve opens and closes. Leave thermostat set at

the mid range.

3.Check outer thermostat cover is tight and free of marks.

4.Remove air filter and replace with spare from Ken-Fix-It trolley.

5.Remove front cover and check drain pan is clear and drain is operating free of restrictions.

6.Check insulation is fixed to cabinet securely.

7.Check for any water leaks from chilled water flexible lines, connections and valve.

8.Remove any dust build up with a wire brush and coat area with rust proofing paint.

9.Clean any dirt build up from the cooling coil and drain pan.

10.Ensure support brackets are secure.

11.Visual check of wiring to ensure plug connections are tight and wiring is in good order and

out of water.

DEPARTMENT: JOB CATEGORY:

REPAIRS AND MAINT. KEN-FIX-IT/HANDYMAN

HEAD: CHIEF ENGINEER G..M. APPROV AL: DA TE:

TASK: FURNITURE REPAIR

STANDARD: FURNITURE WILL BE REPAIRED TO ORIGINAL CONDITION.

======================================================================

PROCEDURE:

Furniture repairs are to be carried out in a professional manner at all times. It is important that repairs carried out are not noticeable and are secure, as they are an receive a lot of abuse.

Questionable furniture will not be put back into use, it will be reported to the Chief Engineer so a disposal notice can be written.

When repairs are carried out, ensure there are no splinters or burrs protruding and it is sanded back in preparation for painting.