豪华油烟机使用说明书中英对照模板

豪华吸油烟机

Luxurious Cooker Hood

安装说明

Installation Instruction

1、安装工具准备, ①冲击电钻( 带钻头)②扳手③螺丝刀④尺

1. Prepare installation tools: ①Impact Electric Drill (with drill) ②Spanner ③Screwdriver ④Ruler

2、确定位置: 吸油烟机平行安装于炉头正上方．底部距炉台安装参考高度

650—750mm,可拆卸挡板安装参考尺寸430mm, 可根据实际的安装情况适当调

整。安装孔距机体应垂直居中和保持水平。

(如煤气炉灶安装说明规定了较大的安装距离者, 对此应予考虑, )例: 吊顶装饰罩( 无拆卸挡板的安装方法)

吊顶装饰罩可拆卸挡板( 有拆卸挡板的安装方法)

2. Determine Installation Site: the hood should be installed over the cooker. The reference setting distance from the bottom to the cooker is 650-750mm. The reference dimension of the dischargeable baffle plate is 430mm. It can be adjusted according to practical installation situation. The mounting hole should align vertical centers and keep horizontal with the cooker hood.

(For instance, if a longer distance is stipulated in the instruction manual

of cooker, it should be considered.)

E.g. suspending ceiling decorative covering (installation method without dischargeable baffle plate )

Suspending ceiling decorative covering dischargeable baffle plate (installation method with dischargeable baffle plate )

3、安装挂脚: 按照挂脚的尺寸在墙壁的相应位置上．钻出直径为8mm ( 严

禁钻孔过大, 造成膨胀管松动而意外跌落)．深度为50一60mm的四个孔, 将

膨胀管压入孔内．再用随机配备的St4X40木螺钉将挂脚可靠固定。

3. Install Hitching Legs: Determine the relevant position on the wall according to the dimensions of the hitching legs. Drill 4 holes with diameter of 8mm (Do not drill holes with too large diameter to prevent accidental fall of cooker hood due to the loose of expansion pipe.) and depth of 50~60 mm. Press the expansion pipe into the holes then fix the hitching legs with St4X40 wood screws accompanied with the machine.

4、安装装饰罩: 揭去装饰罩保护膜．将装饰罩组件由上向下套入机身。装

饰罩长度若不够．可另行向我公司购买。

4. Install Decorative Covering: Disclose the protective layer of the covering and put it on the body of cooker hood from up to down. If the decorative covering is not long enough, you can purchase from our

company.

5、安装机体: 将机体后部的挂孔对准挂脚的按压滑入．用手晃动机体

看是否挂牢。目测机体下沿应水平。如不平, 可调整固定架之水平。

5. Install the Body of Cooker Hood: Make sure the hanging holes in the back of cooker hood are directed at the hookers of the hitching legs and push the cooker hood to make the hookers slip into the holes. Shake the cooker hood to ensure it is fastened. Estimate the lower edge by eyes, and the cooker hood should be horizontal. If not, you can adjust the mounting bracket.

6、安装排风管: 将排风管插入止回阀出风口内外圈之间, 然后将排风管的

另一端接至室外。

6. Install Exhaust Duct: Insert the exhaust duct between inner race and outter race of the air outlet check valve.

豪华吸油烟机

Luxurious Cooker Hood

使用说明

Operation Instruction

照明强档弱档电源

Light High Speed Low Speed Power