倍福同步伺服电机AM30xx

AM3022-wCyz-000a 0.84 Nm 1.39 A 3500 min-1 8000 min-1 8000 min-1 0.161 kg cm² 0.172 kg cm² 1.10 kg 1.37 kg
AM3023-wCyz-000a 1.13 Nm 1.41 A 2500 min-1 5500 min-1 7000 min-1 0.216 kg cm² 0.227 kg cm² 1.38 kg 1.65 kg
alkaline pH range
pressing of the winding head is as possible. For this reason, the
in a highly symmetric struc-
max. 12
required. These measures lead
housings of the AM3000 motor
ture inside the motor reduc-
– chlorine, salt, humid-
to a significant increase in the
series are made from a single
ing cogging to an absolute
ity, corrosion, solvents,
copper filling ratio (which deter- mal resistance of air is higher
can be selected.
version for the food industry.
mines the maximum torque) of than that of epoxy resin. This fur-
the iron core. The wire insulation therefore important to keep the
axial motion of the shaft
– chemical substances/
can be much thinner, since no
heat transfer resistance as small – tight tolerances: resulting
of the whole machine easier.
– chemical substances/
per wire is in close contact with via the mounting flange. It is
– pressed bearings: preventing
acid pH range min. 2
AM3031-wEyz-0000 1.20 Nm 2.99 A 6000 min-1 –
–
0.330 kg cm² 0.341 kg cm² 1.55 kg 1.90 kg
AM3032-wCyz-0000 2.00 Nm 1.44 A 1500 min-1 3000 min-1 3500 min-1 0.590 kg cm² 0.601 kg cm² 2.23 kg 2.58 kg
Option
tional technology, the winding
ity. The winding is sealed in order speeds, so that for each applica- – planetary gear units in
is pressed into the grooved lami- to eliminate air between the
the housing but inside through low moment of inertia, robust
between 0.18 and 53 Nm and
a needle winder. With conven-
design and high overload capac- with a wide range of nominal
(with
(without (with
torque current
brake)
brake)
brake) brake)
AM3011-wB00-000a 0.18 Nm 1.16 A 8000 min-1 –
–
0.017 kg cm² 0a 0.31 Nm 1.51 A 8000 min-1 –
AM3033-wEyz-0000 2.79 Nm 2.58 A 2000 min-1 4500 min-1 5000 min-1 0.850 kg cm² 0.861 kg cm² 2.90 kg 3.25 kg
AM3041-wCyz-0000 1.95 Nm 1.46 A 1200 min-1 3000 min-1 3500 min-1 0.810 kg cm² 0.878 kg cm² 2.44 kg 3.07 kg
benefit is that the motors are
Servomotors are available with – The motors are available
– non-conductive,
significantly shorter than con-
seven different flange sizes. For
AM3041-wEyz-0000 2.02 Nm 2.85 A 3000 min-1 6000 min-1 6000 min-1 0.810 kg cm² 0.878 kg cm² 2.44 kg 3.07 kg
The motor conforms to pro-
approx. 40 %. Furthermore, the ther increases mechanical resil- Features
tection class IP 67 and is
insulation layer has to be signifi- ience, e.g. in case of vibrations. – Rotable plug connectors:
with smooth shaft or with
non-magnetic
ventional models.
each size, once the flange size
groove and feather key.
BECKHOFF New Automation Technology
We reserve the right to make technical changes.
Drive Technology
proportion of “active“ copper,
piece, since material transitions
minimum
scratching
which determines the torque
increase the thermal resistance – feedback option (similar
AM3023-wDyz-000a 1.16 Nm 2.19 A 5000 min-1 8000 min-1 8000 min-1 0.216 kg cm² 0.227 kg cm² 1.38 kg 1.65 kg
AM3024-wCyz-000a 1.38 Nm 1.42 A 2000 min-1 4500 min-1 5500 min-1 0.270 kg cm² 0.281 kg cm² 1.66 kg 1.93 kg
AM3000
AM30xx | Synchronous Servomotors
Pole-wound motor series
Sealed winding
has been defined, there is scope – protection class IP 65,
For the AM3000 servomotors,
The AM3000 servomotors are
for variation in the length. The
shaft bush IP 54
the stator is not wound outside characterised by an extremely
motors are offered with torques – UL/CSA
tion and gear ratio the motor
different variants
nated core. This only achieves a individual wires, since the ther- with the optimum dimensions
– Wash-down: special
AM3032-wDyz-0000 2.04 Nm 2.23 A 2500 min-1 5500 min-1 6000 min-1 0.590 kg cm² 0.601 kg cm² 2.23 kg 2.58 kg
AM3033-wCyz-0000 2.71 Nm 1.47 A 1000 min-1 2000 min-1 2500 min-1 0.850 kg cm² 0.861 kg cm² 2.90 kg 3.25 kg
– further features:
value, so that the performance
and have a negative influence
to the AM2000 series):
– non-porous
of the AM3000 series is approx. on the stability of the motor.
resolver, single-turn and
– temperature-resistant
1108
25–35 % higher. An additional
The AM3000 Synchronous
multi-turn absolute encoders
to 500 °C, UV-resistant
AM3000
AM30uv-wxyz-000a Stand- Stand- Rated speed at rated supply voltage Rotor moment of inertia
Weight Weight
still
still
230 V AC 400 V AC 480 V AC (without
equipped with a stainless
cantly thicker in order to protect
The plug connectors for pow-
steel shaft as well as
the wire from mechanical stress Single-piece motor housing
er and feedback are freely
a sealing ring. The coating
and prevent damage.
Servomotors dissipate a large
rotatable, making wiring
is resistant to:
With pole winding, the cop- proportion of the heat generated
–
0.031 kg cm² –
0.49 kg –
AM3013-wC00-000a 0.41 Nm 1.48 A 8000 min-1 –
–
0.045 kg cm² –
0.63 kg –
AM3021-wCyz-000a 0.48 Nm 1.58 A 8000 min-1 –
–
0.107 kg cm² 0.118 kg cm² 0.82 kg 1.09 kg
AM3024-wDyz-000a 1.41 Nm 2.21 A 4000 min-1 8000 min-1 8000 min-1 0.270 kg cm² 0.281 kg cm² 1.66 kg 1.93 kg
AM3031-wCyz-0000 1.15 Nm 1.37 A 2500 min-1 5000 min-1 6000 min-1 0.330 kg cm² 0.341 kg cm² 1.55 kg 1.90 kg