应急消防泵启动程序

M/V RUI FU FA

INSTRUCTION FOR STARTING EMERGENCY FIRE PUMP

1)OPEN THE V ALVE OF FRESH WATER LINE FROM FRESH W ATER TANK FOR

FILLING SUCTION LINE OF E.F.P

2)TURN THE FL Y- WHEEL OF ENGINE TO START POSITION

3)PUT THE LEVEL ARM OF ENGINE FUEL TO THE MARKED POSITION

4)THE SUCTION V ALVE OF SEA WATER MUST BE OPENED

5)THE DISCHARGE V ALVE OF SEA WA TER ON THE PUMP MUST BE OPENED

6)THE THREE LEVERS ON FIRE PUMP'S ENGINE MUST BE ON START POSITION

7)OPEN THE AIR VENT V ALVE TO DISCHARGE THE AIR INSIDE THE PIPE LINE BY

THE VACCUM PUMP

8)IF THE AIR PRESSURE IS VERY LOW, YOU HA VE TO MOVE THE AIR LEVER UNTIL

THE PRESSURE REACHES 4KG/C㎡

9)TO STOP THE PUMP, MOVE THE FUEL LEVEL ARM TO “0”POSITION

应急消防泵的启动程序

1）打开淡水管上的阀，给应急消防泵吸口管路注水

2）盘车，将飞轮置于启动位置

3）将发动机油门放在启动位置

4）应急消防泵吸口阀必须打开

5）应急消防泵出口阀必须打开

6）应急消防泵发动机缸头上卸压杆放在启动位置

7）打开放气阀通过操纵真空泵来排出管路中的气体

8）若气瓶压力较低时，必须再次操作启动空气至压力达到4KG/C㎡为止

9）将燃油手柄放在0位置时，停止应急消防泵