探放水钻孔止水套管安装方法与流程

探放水钻孔止水套管安装方法与流程
1.首先确定止水套管的尺寸和数量，确保与水钻孔的尺寸相匹配。

Firstly, determine the size and quantity of the water
stop collar to ensure it matches the size of the borehole.
2.清理水钻孔周围的杂物和泥浆，确保止水套管能够顺利安装。

Clean the debris and mud around the borehole to ensure smooth installation of the water stop collar.
3.将止水套管的两端用防水胶进行处理，以防止水的渗漏。

Seal both ends of the water stop collar with waterproof adhesive to prevent water leakage.
4.将止水套管缓慢下降到水钻孔中，直到完全位于所需位置。

Slowly lower the water stop collar into the borehole
until it is fully in position.
5.使用橡胶锤小心敲击止水套管，使其与水钻孔之间形成紧密的
连接。

Carefully tap the water stop collar with a rubber hammer
to create a tight connection between the collar and the borehole.
6.检查止水套管是否平整、垂直，并且与钻孔壁面贴合紧密。

Check that the water stop collar is flat, vertical, and snug against the borehole wall.
7.根据需要，使用扳手或其他工具对止水套管进行调整，确保其
紧密安装在位。

Use a wrench or other tools as needed to adjust the water stop collar to ensure a tight fit in place.
8.在止水套管的接缝处进行密封处理，以确保水不会从缝隙渗漏。

Seal the joints of the water stop collar to ensure that water does not leak from the gaps.
9.等待密封胶完全干固后，进行最终的检查，确保止水套管安装牢固可靠。

Wait for the sealant to completely dry before performing a final inspection to ensure the water stop collar is securely installed.
10.清理工作场地，将杂物和工具清理干净，确保安装环境整洁。

Clean up the work site, removing debris and tools to ensure a tidy installation environment.
11.按照相关安全规定撤离工作场地，确保安全操作。

Evacuate the work site according to relevant safety regulations to ensure safe operation.
12.验收安装工作，确保止水套管符合相关标准和规范。

Inspect the installation to ensure that the water stop collar meets relevant standards and specifications.。