V-472中英文说明书模板7p

欢迎阅读Thank you for choos ing the products of svavo compa ny, may it will bring convenience for your furture life.
Don't put the soap dispe nser device on mirror or reflective str ong surface, don't put the soap dispe nser device on
un derwater
3. 在强光下使用皂液器，可能会影响感应灵敏度。

It might affect induction sensitivity when use the soap dispenser under the strong sun light.
4. 该产品适合浓度适中的液体，液体浓度过高会有出液缓慢或不出液的现象。

This product is suitable for the liquid concen trati on is moderately,if the liquid concen trati on is too high it will
result in liquid flow too slow or stop flow the liquid.
5.
不能使用酒精或其他化学液体。

Please don 'use alcohol or other chemical liquid. 6. 请不要让灰尘掉进肥皂分配器里，这样可能会堵塞通道口，如果你发现容
器已脏或有杂质，请重新换进肥皂剂。

Please don't let the dust into soap dispenser, that may jam access point, if you find some dirty or impurity in the
container, please cha nge soap liquid.
7. 要经常使用皂液器，如果长时间不用皂液器，液体肥皂剂可能会凝固，请 倒出皂液，并清洁干
净本品。

I ■
Please use soap dispenser frequently, if you don ' use it for a long time, the liquid soap may solidification, then please pour out the liquid and clea n up the soap dispe nser.
8. 如果液体肥皂剂还剩几乎1cm 时，请加入肥皂剂
Please add soap whe n the liquid soap left about 1cm high.
9 清洁皂液器
Clea n the soap dispe nser
（1） 当不用时请倒出里面的液体肥皂剂，用抹布擦干净并拿出下面的电池。

Please pour out the liquid when don ' use the dispenser,clean up with a rag wipe and take out the battery
（2） 请勿把皂液器放进水里清洗，这样会损坏电路板。

Please don ' t put the soap dispenser into the water when clean it, that might damage the circuit board.
（3） 清洁皂液器表面用湿布和干毛巾，清洁电池盒只能用干毛巾。

Clea n soap dispe nser 'surface with wet cloth and dry towel but you can use dry towel to clea n battery box only.
（4） 请勿用强腐蚀性化学溶剂清洁产品，以免造成外观表面损坏、变形。

Do not use stro ng corrosive chemical solve nts to clea n the products, to avoid the surface be damaged and
- A I j " J — ______________________________ —'
deformati on. _l. _ 'I
使用说明：
in structi ons
1. 将档位开关拨至I 档
2•伸手靠近感应区，出液口出液（第一次使用时由于皂液还没有流 入通液管道中，请来回运行数
次直至出液）
Put the hand near the inductive zone and the mouth flow out fluid.Please run around several times until the liquid flow out of the dispe nser whe n the first time use it because of the soap have n ' flow into the liguid pipe.
3. 该产品为一次感应，把手放在皂液器的出液口下，皂液将会自动 运作一次，如需继续请重复第
2步骤。

The product is a on etime in ducti on, put the hand un der the soap mouth, it will automatically Work one time, if necessary please repeat the step 2.
4. 调节出液量
Adjust a fluid volume
整机设有两个档位，将档位开关拨至I 档，皂液器开起同时也是一档，拨至II 档则是二档 The machine has two gear, make the gear switch to I , and make the machine work on I ,so as to the n .
Make gear switch to I file
The mach ine will be off whe n you tur n it to the gear on OFF.
常见故障及处理：
Common fault and process ing
1. 如果皂液器不工作
If the soap dispenser don ' t work
(1)把您的手靠近感应器。

Put your hand n ear the soap dispe nser
(2)检查是否连接电源。

Make sure the curre nt have conn ect.
(3)开关是否打开，请将开关打开。

Please make sure have turn on the switch.
(4)检查皂液器的下表面，如果下表面有很多光和倒影，请移动皂液器到适当的位置。

Check the under surface of the soap dispenser, if there are much light and shadow under the bottom, please move the soap dispe nser to the right positi on.
2. 如果无皂液滴下
If the soap dispenser don ' t flow the liquid
(1)如果第一次使用，在输液管里有残留的空气，请运作皂液器数次。

If you use it at the first time , some air may remain in the tubing, please operation the soap dispenser several times (2)在冬天气温较低时，液体有可能会凝结，请倒入一些温水( 60C左右)
等待数分钟后，运行皂液器数次即可。

The liquid may be froze n in the cold win ter, please add some warm water (aro und 60 degree),wait a few mi nu tes and operate the mach ine.
(3)可能皂液不够，请添加皂液。

May be the soap is not eno ugh, please add the soap.。