Supera HOT DOG STEAMER DOG-1200-1 用户指南说明书

DOG-1200-1 HOT DOG STEAMER INSTRUCTION MANUAL
I N S T R U C T I O N M A N U A
L
WARNINGS
• Do not touch any hot surfaces
• Do not immerse unit, cord or plug in liquid at any time
• Unplug cord from outlet when not in use and before cleaning
• Plug only into a 3-hole grounded electrical outlet
• Do not operate unattended
• Do not use this unit for anything other than intended use
• Do not use outdoors
• Always use on a fi rm, dry and level surface at least 12” from walls or any other obstruction
• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has
been damaged in any manner
• Keep children and animals away from unit
• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to
property loss and injury. All repairs should be done by authorized professionals only
• Ensure that the designated power supply is adequate for continual usage and the voltage is
correct
TO INSTALL
1. Remove unit from the box and remove all parts.
2. With the operator side facing you (dial to the left) set it down on a fl at sturdy surface.
3. Open the top fl aps of the unit and remove the parts and packing foam. Put the parts to the
side.
4. Slide in glass windows for both the back and front of the unit.
5. Pour six quarts of water into the base of the unit to cover the heating element. DO NOT OVER-
FILL. It is recommended that you use hot water to reduce preheat time. Make sure valve drain
cap is screwed tightly closed.
6. Once the water is in, place the perforated rectangular base on the left side of the unit.
7. Place the square base plate with the control lever on the right side of the unit.
8. Slide the partition piece into the left slots to separate the hot dog and bun sections of the
steamer.
9. Place the hot dog rack to the of the left side compartment. Make sure the rack is standing on
its feet to allow proper circulation of steam.
10. Place the bun rack on the right side in the bun compartment.
11. Place lid beam in the middle of the unit so the lids rest on the edges of the beam.
12. Place lids down on unit edges and swing closed. Adjust lid beam to fi t if needed.
13. Ensure that the unit is plugged into a grounded and properly-sized electrical outlet to minimize
shock or fi re hazard. Refer to the electrical requirements on the serial tag located on the op-
erator side of the unit.
14. Turn the switch on and set the thermostat control on the highest setting until steam is
generated.
15. For normal operation, set the thermostat control in the center of the range between the highest
and lowest temperature (130°F ).
16. Place hot dogs in the small compartment and buns on the wire rack in the large compartment.
Arrange the hot dogs and buns so that there is enough room for circulation of steam.
17. T o control the amount of steam in the bun compartment, use the adjustable humidity control
lever located in the bun compartment under the wire rack.
18. Keep lids closed when not serving.
19. Add hot water when necessary to maintain the water level. Do not allow the unit to burn dry. If
you accidentally run it dry, turn off and allow the unit to completely cool before adding water.
Adding water to a dry unit while it is still hot could cause damage to the elements.
I N S T R U C T I O N M A N U A
L Wiring Diagram for the Hot Dog Steamer
CLEANING – NOTE: T o maintain cleanliness and increase service life, the hot dog
steamer should be cleaned daily. Do not immerse the unit in water or any other
liquid. If liquid enters the electrical compartment it may cause a short circuit or elec-
trical shock.
1. Disconnect the power cord from the electrical outlet.
2. Allow the unit to cool down completely.
3. Remove any remaining hot dogs and buns.
4. Drain the water using the drain pipe located on the operator side.
5. Detach all removable parts including the bun rack, perforated trays, steam control
lever, partition and glass panels. Thoroughly clean the unit. Although stainless
steel is corrosion resistant, for longevity purposes the unit should be cleaned after
every use.
TROUBLESHOOTING
Troubles listed are for reference. If any fault occurs, please discontinue use. Do not
attempt to repair yourself. This will void the warranty.
Problem: Condensation on glass
Cause: Cool air striking the warm surface of the steamer
Solution: Avoid placing the unit against cool drafts of air
Problem: Hot dog casing burst Cause: T oo much steam is being generated Solution: Reduce the thermostat control to a lower setting
Problem: Buns too soggy
Cause: T oo much steam is being generated
Solution: Adjust the steam control level
Problem: Buns too dry
Cause: T oo much steam is being generated
Solution:
Adjust the steam control level
I N S T R U C T I O N M A N U A
L
Parts Diagram and Replacement Parts for the Hot Dog Steamer
I N S T R U C T I O N M A N U A
L
Replacement Parts for the Hot Dog Steamer g
Reference
Number Part Number Description
1Rear Panel
2Body Shell
3HDS-3 Lid with Handle
4Lid Support
5HDS-5Bakelite Handle
6HDS-6Heating Element
7HDS-7Drainage Pipe
8Control Box Cover Plate
9Control Box Cover Plate
10Warning Plate
11HDS-11Drainage Cover Plate
13Drainage Plug
14Drainage Cover Plate Fixture
15HDS-15Manual Thermal Limiter
16HDS-16Knob with Bottom Plate
18Logo
19HDS-19On/Off Switch with light
20HDS-20EGO Thermostat
21HDS-21Rubber Foot
22Body Support Rack
23HDS-23Glass
24HDS-24Hot Dog Rack
25Small Layer Plate
26Separate Plate
27HDS-27Bread Basket
28Anti-Leakage Plate
29Big Layer Plate
30HDS-30 Power Cord and Strain Releif
31S/S Screws
32Rivet
LIMITED WARRANTY
SUPERA COUNTERTOP COOKING EQUIPMENT MODELS:
Hot Dog Steamers: [DOG-1200-1]
Hot Dog Roller Grills: [RGL5-1, RGL7-1, RGL9-1]
Hot Dog Roller Grill Covers: [RGL5C-1, RGL7C-1, RGL9C-1]
Bun Warmers: [BUN-450-1]
Claims: All claims for parts or labor must be made directly through SUPERA, LLC. All claims should include: model number of the unit, the serial number of the unit, proof of purchase, date of installation, and all pertinent information supporting the alleged defect. Failure to comply with warranty policies will result in voiding claims. Any service provided without authorization from Supera, LLC will not be covered by Supera, LLC.
One-Year Parts & Labor Warranty:SUPERA, LLC warrants to the original purchaser of new equipment that said equipment, when installed in accordance with our instructions within North America and subjected to normal use, is free from defects in material or workmanship for one year. Warranty includes onsite service calls within 60 miles of an authorized service company. End user is responsible for all extra travel and mileage at prevailing rates and for original call to Supera expressing need for warranty service. Any service provided without authorization from Supera, LLC will not be covered by Supera, LLC.
EXCLUSIONS: Example of items not covered under warranty, but not limited to only these items:
1) Acts of God, fire, water damage, burglary, accident, theft
2) Freight damage
3) Improper installation or alteration of equipment
4) Use of generic or after market parts.
5) Repairs made by anyone other than a SUPERA designated servicer
6) Lubrication
7) Expendable wear parts, adjustable feet, blown fuses, lamps, etc
8) Cleaning of equipment
9) Misuse or abuse
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED. SUPERA EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OR EXPRESSED OR IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. SUPERA, LLC HAS FINAL DESCRETION ON ALL WARRANTY REQUESTS.
SUPERA’S OBLIGATIONS:SUPERA’S OBLIGATION AND LIABILITY UNDER THIS WARRANTY IS EXPRESSLY LIMITED TO REPAIRING AND REPLACING EQUIPMENT WHICH PROVES TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP WITHIN THE APPLICABLE WARRANTY PERIOD.
All repairs pursuant to this Warranty will be performed by an Authorized Designated SUPERA Service Location during normal working hours. This warranty does not cover services performed at overtime or premium labor rates. End user is responsible for the difference between normal service rates and premium service rates. This warranty does not cover any service technician errors. IN NO EVENT SHALL SUPERA BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES TO BUYER OR ANY THIRD PARTY, INCLUDING, WITHOUT LIMITATION, LOSS OF PROPERTY, PERSONAL INJURY, LOSS OF BUSINESS OR PROFITS OR OTHER ECONOMIC LOSSES, OR STATUTORY OR EXEMPLARY DAMAGES, WHETHER IN NEGLIGENCE, WARRANTY, STRICT LIABILITY, OR OTHERWISE.
This warranty is given only to the first purchaser from a retail dealer. No warranty is given to subsequent transferees. Installation in a residential application will void all warranties.
Warranty does not cover product failures caused by: failure to maintain, neglect, abuse, damage due to excess water, fire, normal wear, improper set up and use. Periodic maintenance is not covered. Warranty does not cover service requests for free replacement and/or recall parts.
THE FOREGOING WARRANTY PROVISIONS ARE A COMPLETE AND EXCLUSIVE STATEMENT BETWEEN THE BUYER AND SELLER. SUPERA NEITHER ASSUMES NOR AUTHORIZES ANY PERSONS TO ASSUME FOR IT ANY OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH SAID EQUIPMENT.
Not Covered Under This Warranty: SUPERA, LLCʼs sole obligation under this warranty is limited to either repair or replacement of parts, subject to the additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other than those expressly covered by this warranty. Warranty does not cover service requests for free replacement and/or recall parts.
SUPERA, LLC HAS FINAL DESCRETION ON ALL WARRANTY REQUESTS.NO CONSEQUENTIAL DAMAGES. SUPERA, LLC IS NOT RESPONSIBLE FOR ECONOMIC LOSS; PROFIT LOSS; OR SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOSSES, SERVICE TECHNICAN ERRORS, OR DAMAGES ARISING FROM FOOD OR PRODUCT SPOILAGE REGARDLESS OF WHETHER OR NOT THEY RESULT FROM REFRIGERATION FAILURE. WARRANTY
IS NOT TRANSFERABLE, This warranty is not assignable and applies only in favor of the original purchaser/user to whom delivered. ANY SUCH ASSIGNMENT OR TRANSFER SHALL VOID THE WARRANNTIES HEREIN AND SHALL VOID ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR LABOR COVERAGE FOR COMPONENT FAILURE OR OTHER THE WARRANTY PACKET PROVIDED WITH THE UNIT. ALTERATION, NEGLECT, ABUSE, MISUSE, ACCIDENT, DAMAGE DURING TRANSIT OR INSTALLATION, FIRE, FOOD, ACTS OF GOD. SUPERA, LLC is not responsible for the repair or replacement of any parts that SUPERA, LLC determines have been subjected after the date of manufacture to alteration, neglect, abuse, misuse, accident, damage during transit or installation, fire, flood, or act of GOD. IMPROPER ELECTRICAL CONNECTIONS. SUPERA, LLC IS NOT RESPONSIBLE FOR THE REPAIR OR REPLACEMENT OF FAILED OR DAMAGED COMPONENTS RESULTING FROM ELECTRICAL POWER FAILURE, THE USE OF EXTENSION CORDS, LOW VOLTAGE, OR VOLTAGE DROPS TO THE UNIT. NO IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE; THERE ARE NO OTHER WARRANTIES, EXPRESSED, IMPLIED OR STATUTORY, EXCEPT THE TWO (2) YEAR PARTS & LABOR WARRANTY AND THE ADDITIONAL THREE (3) YEAR COMPRESSOR WARRANTY AS DESCRIBED ABOVE. THESE WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, INCLUDING IMPLIED WARRANTY AND MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THERE ARE NO WARRANTIES, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. Outside U.S. and Canada; this warranty does not apply, and SUPERA, LLC is not responsible for, any warranty claims made on products sold or used outside the continent of the United States and Canada. Installation in a residential application will void all warranties.
FOR WARRANTY AND NON-WARRANTY related issues, technical support, purchase replacement parts and warranty registration call 866-953-3288 for technical support. Please have your model number, serial number and proof of purchase ready.。