A330 ATA章节中英文对照表

00 DIMENSIONS AND AREAS - GENERAL
10 DIMENSIONS AND AREAS
非商业航班所需求的维修工作
尺寸和面积-概述 尺寸和面积-概述
20 ZONING
区域
30 STATIONS
站位
31 STATIONS 40 ACCESS 41 ACCESS
站位 接近 接近
00 LIFTING AND SHORING - GENERAL
吊架和包皮门
25 STABILIZERS
水平安定面
31 COCKPIT
驾驶舱
11
32 CABIN 33 AVIONICS COMPARTMENT
客舱 电子舱
34 LANDING GEAR WELLS
起落架舱
35
LOWER DECK CARGO COMPARTMENTS ((FWD, AFT AND BULK)
消磁
56
MEASUREMENT AFTER THE AIRCRAFT
ABNORMAL
OPERATION
OF
飞机非正常操作后的测量
57 AIRCRAFT STABILITY
飞机稳定性
59
NON-REVENUE FLIGHT - REQUIREMENTS FOLLOWING MAINTENANCE ACTIONS
顶升和支撑-概述
10 JACKING
顶升
11 JACKING FOR A/C MAINTENANCE OPERATIONS 飞机维护操作顶升
12 JACKING FOR WHEEL CHANGE
换轮的顶升
20 SHORING
固定
00 LEVELING AND WEIGHING - GENERAL
水平和称重-概述
11 WIRELOCKING
保险丝
15 ELECTROSTATIC DISCHARGE SENSITIVE
静电敏感设备
16 CIRCUIT BREAKERS
跳开关
17 MAINTENANCE IN STORM CONDITIONS
暴雨条件维护
20 STANDARD PROCESSES
标准程序
21 STANDARD TORQUES
下货舱（前、后和散货舱）
36
BELLY FAIRING, AIR CONDITIONING AND HYDRAULICS COMPARTMENTS
机腹整流罩，空调和液压舱
37 WING, REAR FUSELAGE AND TAIL SECTIONS 大翼，后机身和尾部
38 RADOME
雷达罩
42 CABIN
增压控制和监控
21
40 HEATING
加温
42 DOOR AND GALLEY AREAS HEATING
门和厨房区域加温
43
LOWER DECK CARGO COMPARTMENT HEATING FWD, AFT AND BULK
下货舱加温，（前、后和散货 舱通风）
50 AIR COOLING
空气冷却
11
AUTOPILOT/FLIGHT DIRECTOR (AP/FD) ENGAGEMENT
自动驾驶/飞行指引（AP/FD） 接通
12
AUTOPILOT/FLIGHT DIRECTOR (AP/FD) CRUISE MODES
自动驾驶/飞行指引（AP/FD） 巡航模式
13
AUTOPILOT/FLIGHT DIRECTOR (AP/FD) COMMON MODES
客舱空气分配和再循环
22 COCKPIT AIR VENTILATION
驾驶舱通风
23 LAVATORY/GALLEY VENTILATION
厕所/厨房通风
25 AIR CONDITIONING COMPARTMENT
空调舱通风
26 AVIONICS EQUIPMENT VENTILATION
电子舱通风
LATERAL FUNCTIONS
能
73
FLIGHT MANAGEMENT (FM)- PERFORMANCE / 飞行管理（FM）- 性能/垂直功
VERTICAL FUNCTIONS
能
74 FLIGHT MANAGEMENT(FM) - OPERATIONAL USE 飞行管理（FM）- 操作使用
客舱
00 SERVICING - GENERAL
勤务-概述
10 REPLENISHING
补充
11 FUEL
燃油
12 HYDRAULIC FLUIDS
液压油
13 OIL
滑油
14 GAS
气体
15 WATER
水
16 LAVATORY
厕所
17 RAIN REPELLENT
排雨液
20 SCHEDULED SERVICING
飞行包线计算
70 FLIGHT MANAGEMENT (FM)
飞行管理（FM）
71
FLIGHT MANAGEMENT (FM) - FLIGHT PLAN/DATA BASE
飞行管理（FM）- 飞行计划/数 据库
72
FLIGHT MANAGEMENT (FM) - NAVIGATION / 飞行管理（FM）- 导航/横向功
恢复运行
00 PLACARDS AND MARKINGS - GENERAL
标牌和标志-概述
20 EXTERIOR PLACARDS AND MARKINGS
外部标牌和标志
21 FUSELAGE
机身
22 LANDING GEARS
起落架
23 WINGS
大翼
24 PYLONS AND COWL DOORS
电缆和扎线
28 ELECTRICAL BONDING
电气接地
29 O-RING INSTALLATION
O型封圈安装
31
LIST OF SERVICE
MATERIALS REQUIRED AND MAINTENANCE
FOR
AIRCRAFT
飞机勤务和维护的航材清单
33
LIST OF MATERIALS REQUIRED FOR APU SERVICE AND MAINTENANCE
区域检查：水平安定面和机身 后段
24
ZONAL INSPECTION: POWER PLANT, NACELLES 区域检查：动力装置，吊舱和
AND PYLONS
吊架
25 ZONAL INSPECTION: WING
区域检查：大翼
27
ZONAL INSPECTION: LANDING GEAR AND LANDING GEAR DOORS
区域检查：起落架和起落架舱 门
28
ZONAL CARGO EXITS
INSPECTION: COMPARTMENT
PASSENGER/CREW DOORS, DOORS AND EMERGENCY
区域检查：旅客/机组舱门，货 舱门和应急门
50 UNSCHEDULED MAINTENANCE CHECKS
28
LOWER DECK CARGO COMPARTMENT VENTILATION AND COOLING FWD, AFT AND
下货舱通风和冷却，（前、后 和散货舱通风）
30 PRESSURIZATION CONTROL
增压控制
31 PRESSURE矩
22 STA-LOK FASTENERS
STA-LOK紧固件
23 LINES
管路
20
24 CONTROL CABLES AND PULLEYS
控制钢索和滑轮
20
26 INSTALLATION OF EXPANSION JOINT
膨胀接头的安装
27 ELECTRICAL CABLES AND BUNDLES
滑行
00
PARKING, MOORING, STORAGE & RETURN TO 停留，系留，储存和恢复运行-
SERVICE - GENERAL
概述
10 PARKING/STORAGE
停留/储存
11 PARKING
停留
12 STORAGE
储存
20 MOORING
系留
30 RETURN TO SERVICE
例行勤务
12
21 CLEANING 22 LUBRICATION
清洁 润滑
24 DRAINAGE
排放
28
USE OF MANUAL MAGNETIC FUEL QUANTITY INDICATORS
燃油量油尺的使用
30 UNSCHEDULED SERVICING
非例行勤务
31
COLD WEATHER MAINTENANCE - AIRCRAFT PROTECTION
自动驾驶/飞行指引（AP/FD） 一般模式
30 AUTOTHRUST
自动推力
31 AUTOTHRUST ENGAGEMENT
自动推力接通
32 AUTOTHRUST MODES
自动推力模式
60 FLIGHT ENVELOPE (FE)
飞行包线（FE）
61 CONFIGURATION
构型
62 FLIGHT ENVELOPE COMPUTATION
PRINTER FUNCTIONS
打印机功能
80
FLIGHT MANAGEMENT, GUIDANCE AND ENVELOPE SYSTEM (FMGES)
飞行管理，制导，包络系统 （FMGES）
81 FLIGHT CONTROL UNIT (FCU)
寒冷天气维护-飞机保护
32 SAMPLING FOR ANALYSIS
取样分析
33 PRE-CONDITIONING
飞机地面的预调温
34 GROUNDING POINTS
接地点
36 SYSTEM LINE FLUSHING
系统管道清洗
00 STANDARD PRACTICES - AIRFRAME - GENERAL 标准施工-机身-概述
APU勤务和维护的航材清单
34
LIST OF MATERIALS REQUIRED FOR IDG SERVICE AND MAINTENANCE
IDG勤务和维护的航材清单
00 AIR CONDITIONING - GENERAL
空调-概述
20 DISTRIBUTION
分配
21 CABIN AIR DISTRIBUTION AND
非例行维护检查
51 INSPECTIONS
检查
PRESSURIZATION TEST OF FUSELAGE 53 (LEAKAGE CHECKS) AFTER A/C ABNORMAL
OPERATION OR REPAIR
飞机非正常操作或维修后的机 身增压测试（渗漏检查）
54 DEMAGNETIZATION
10 WEIGHING AND BALANCING
载重和平衡
20 LEVELING 21 QUICK LEVELING 22 PRECISE LEVELING
水平 快速校水平 精确校水平
00 TOWING AND TAXIING - GENERAL
牵引和滑行-概述
10 TOWING
牵引
20 TAXIING
21 ZONAL INSPECTION: LOWER HALF OF
时限-维护检查-概述 例行维护检查-维修手册程序 区域检查：机身下半部
22 ZONAL INSPECTION: UPPER HALF OF
区域检查：机身上半部
23
ZONAL INSPECTION: STABILIZERS AND FUSELAGE REAR SECTION
CHAPTER
05
06 07 08 09 10
A330-200/300
SECTION
DISCRIPTION_ENGLISH
DISCRIPTION_CHINESE
00 TIME LIMITS - MAINTENANCE CHECKS -
20
SCHEDULED MAINTENANCE CHECKS MAINTENANCE MANUAL PROCEDURE
22
75
FLIGHT MANAGEMENT (FM) - ELECTRONIC INSTRUMENT SYSTEM (EIS) DISPLAYS
飞行管理(FM)- 电子仪表系统 （EIS）显示
76
FLIGHT MANAGEMENT (FM) - DATA LINK AND 飞行管理（FM）- 数据链接和
51 FLOW CONTROL AND INDICATING
流量控制和指示
52 AIR CONDITIONING PACKS
空调组件
53 PACK CONTROL AND INDICATING
组件控制和指示
55 EMERGENCY RAM AIR INLET
应急冲压空气进口
58 CONDITIONED SERVICE AIR SYSTEM (CSAS) 调温的服务空气系统
60 TEMPERATURE CONTROL
温度控制
63 COCKPIT AND CABIN TEMPERATURE CONTROL 驾驶舱和客舱温度控制
00 AUTO FLIGHT - GENERAL
自动飞行-概述
10 AUTOPILOT/FLIGHT DIRECTOR (AP/FD)
自动驾驶/飞行指引（AP/FD）