外文期刊的论文要求格式

Your Paper's Title Starts Here: Please Center
use Helvetica (Arial) 14
FULL First Author1, a, FULL Second Author2,b and Last Author3,c
1Full address of first author, including country
2Full address of second author, including country
3List all distinct addresses in the same way
a email,
b email,
c email
Keywords: List the keywords covered in your paper. These keywords will also be used by the publisher to produce a keyword index.
For the rest of the paper, please use Times Roman (Times New Roman) 12
Abstract. This template explains and demonstrates how to prepare your camera-ready paper for Trans Tech Publications. The best is to read these instructions and follow the outline of this text. Please make the page settings of your word processor to A4 format (21 x 29,7 cm or 8?x?11 inches); with the margins: bottom 1.5 cm (0.59 in) and top 2.5 cm (0.98 in), right/left margins must be 2 cm (0.78 in).(We shall be able to publish your paper in electronic form on our web page , if the paper format and the margins are correct. If not, we will have to scan your paper which, when compared with an electronic version, results in very poor quality)
Your manuscript will be reduced by approximately 20% by the publisher. Please keep this in mind when designing your figures and tables etc.
Introduction
All manuscripts must be in English, also the table and figure texts, otherwise we cannot publish your paper.
Please keep a second copy of your manuscript in your office. When receiving the paper, we assume that the corresponding authors grant us the copyright to use the paper for the book or journal in question. Should authors use tables or figures from other Publications, they must ask the corresponding publishers to grant them the right to publish this material in their paper.
Use italic for emphasizing a word or phrase. Do not use boldface typing or capital letters except for section headings (cf. remarks on section headings, below).
Organization of the Text
Section Headings. The section headings are in boldface capital and lowercase letters. Second level headings are typed as part of the succeeding paragraph (like the subsection heading of this paragraph).
Page Numbers. Do not number your paper:
Tables. Tables (refer with: Table 1, Table 2, ...) should be presented as part of the text, but in such a way as to avoid confusion with the text. A descriptive title should be placed above each table. Units in tables should be given in square brackets [meV]. If square brackets are not available, use curly {meV} or standard brackets (meV).
Special Signs. for example , αγμΩ () ≥ ± ● Γ {1120}should always be written in with the fonts Times New Roman or Arial, especially also in the figures and tables.
Macros. Do not use any macros for the figures and tables. (We will not be able to convert such papers into our system)
Language. All text, figures and tables must be in English.
Figures. Figures (refer with: Fig.?1, Fig.?2, ...) also should be presented as part of the text, leaving enough space so that the caption will not be confused with the text. The caption should be self-contained and placed below or beside the figure. Generally, only original drawings or photographic reproductions are acceptable. Only very good photocopies are acceptable. Utmost care must be taken to insert the figures in correct alignment with the text. Half-tone pictures should be in the form of glossy prints. If possible, please include your figures as graphic images in the electronic version. For best quality the pictures should have a resolution of 300 dpi(dots per inch).
Color figures are welcome for the online version of the journal. Generally, these figures will be reduced to black and white for the print version. The author should indicate on the checklist if he wishes to have them printed in full color and make the necessary payments in advance.
Equations.Equations (refer with: Eq.?1, Eq.?2, ...) should be indented 5 mm (0.2"). There should be one line of space above the equation and one line of space below it before the text continues. The equations have to be numbered sequentially, and the number put in parentheses at the right-hand edge of the text. Equations should be punctuated as if they were an ordinary part of the text. Punctuation appears after the equation but before the equation number, e.g.
c2 = a2 + b2. (1)
Literature References
References are cited in the text just by square brackets [1]. (If square brackets are not available, slashes may be used instead, e.g. /2/.) Two or more references at a time may be put in one set of brackets [3,4]. The references are to be numbered in the order in which they are cited in the text and are to be listed at the end of the contribution under a heading References, see our example below. Summary
If you follow the “c hecklist”your paper will conform to the requirements of the publisher and facilitate a problem-free publication process.
References
[1] Dj.M. Maric, P.F. Meier and S.K. Estreicher: Mater. Sci. Forum Vol. 83-87 (1992), p. 119
[2] M.A. Green: High Efficiency Silicon Solar Cells (Trans Tech Publications, Switzerland 1987).
[3] Y. Mishing, in: Diffusion Processes in Advanced Technological Materials, edtied by D. Gupta
Noyes Publications/William Andrew Publising, Norwich, NY (2004), in press.
[4] G. Henkelman, G.Johannesson and H. Jónsson, in: Theoretical Methods in Condencsed Phase
Chemistry, edited by S.D. Schwartz, volume 5 of Progress in Theoretical Chemistry and Physics, chapter, 10, Kluwer Academic Publishers (2000).
[5] R.J. Ong, J.T. Dawley and P.G. Clem: submitted to Journal of Materials Research (2003)
[6] P.G. Clem, M. Rodriguez, J.A. Voigt and C.S. Ashley, U.S. Patent 6,231,666. (2001)
[7]
从这里开始你的论文的标题：请中心
使用Helvetica字体（宋体）14
全第一Author1，整个第二Author2，B和最后Author3
1Full地址的第一作者，包括国家
第二作者2Full地址，包括国家
3List所有不同的地址，以同样的方式
aemail，bemail，cemail
关键词：列出你的论文中所涉及的关键字。

出版商也可以使用这些关键字将产生一个关键字索引。

对于本文的其余部分，请使用罗马时报“（Times New Roman的）12
抽象的。

此模板说明，并演示了如何准备跨科技刊物您的相机准备好纸。

最好是阅读这些说明，并按照这个文本的轮廓。

请让您的文字处理器中的页面设置为A4格式（21 ×29.7厘米或8× 11英寸）;与边缘：底部1.5厘米（0.59）和2.5厘米（0.98），左/右页边距必须为2厘米
您的稿件将减少约20％由出版商。

请记住这个设计时，您的数字和表格等
简介
所有稿件必须用英文，也表和图的文本，否则我们无法发布您的文件。

请保持您的稿件的第二个副本，在你的办公室。

当接收到的文件，我们承担相应的作者给予我们的版权使用问题的书或杂志纸。

作者应使用表或其他出版物的数字，他们必须提出相应的出版商给予他们的权利，在他们的论文发表这种材料。

使用斜体强调一个词或短语。

不要使用除节标题（参见备注部分的标题，下同）黑体打字或大写字母。

组织文本
区段标题。

本节的标题是粗体的资本和小写字母。

第二级标题类型为后续段的一部分（如本段小节标题）。

页码。

不要数你的文件：
表。

表（参考：表1，表2，... ...）应作为文本的一部分，但以这样的方式，以避免混乱的文本。

一个描述性的标题应放在上述每个表。

表中的单位，应在方括号[MEV]。

如果方括号中是不可用的，使用的卷曲{MEV}或标准括号（MEV）。

特殊标志。

例如，αγμ欧姆（）≥±●Γ{11 0}应始终书面字体Times New Roman或Arial 字体，尤其是在数字和表格。

宏。

不要使用任何的数字和表格宏。

（我们将无法转换成我们的系统文件）
语言。

所有文字，数字和表格必须用英文。

图。

数字（参考用：图1，图2，...。

）也应作为文本的一部分，留出足够的空间这样的CAPT?离子不会与文本混淆。

标题应自成体系，并置于图下方或旁边。

一般来说，只有原始图纸或照片的复制品是可以接受的的。

只有非常良好的影印本是可以接受的的。

插入文本正确对齐的数字，必须采取极为谨慎。

半色调图片应该光泽打印的形式。

如果可能的话，请包括您的电子版图形图像的数字。

为获得最佳质量的图片，应该有一个分辨率为300 dpi（每英寸点数）。

颜色数字是该杂志的在线版本欢迎。

一般来说，这些数字将减少为黑色和白色的印刷版。

笔者的清单上注明，如果他希望他们在全彩色印刷，并事先做好必要的支付
方程。

方程（参考用式1，式2，...）。

应缩进5毫米（0.2“）的文本继续之前，应该有空间上面的方程和它下面的空间一行一行方程按顺序编号，并在右侧边缘的文字括号中的数字。

方程应穿插，好像他们是一个普通的文本的一部分。

标点符号后出现的方程，但方程号码之前，如
C2 = A2 + B2。

文献引用
在文中引用文献[1]方括号。

（如果不可用方括号，斜杠可能被用来代替，如/2/）可能会在两个或更多的时间引用放在一个括号[3,4]。

引用他们在文中引用的顺序编号，标题下的引用要上市的贡献，看到我们的例子。

摘要
如果按照“清单”您的文件将符合出版商的要求，促进问题的自由的出版过
参考文献
[1] Dj.M.马里奇，P.F. Meier和S.K. Estreicher：母校。

SCI。

论坛卷。

83-87（1992），第119
[2]马绿：高效率硅太阳能电池（科技刊物，1987年瑞士）。

[3] Y. Mishing，在扩散过程中先进的技术材料，D.古普塔诺伊斯刊物/威廉安德鲁Publising，诺威治，纽约州（2004年）edtied的记者，。

[4 Henkelman，G. Johannesson和H ·琼森，Condencsed相化学理论方法，通过SD编辑施瓦茨，理论化学与物理，章，10，Kluwer学术出版社（2000年）的进展第5卷。

[5] R.J.王景荣，J.T. Dawley和P.G.克莱姆：提交材料研究学报（2003）
[6] P.G.克莱姆，M.罗德里格斯，J.A.福格特和C. S.阿什利，美国专利6231666。

（2001）。