OPA606

±126 ±566 ±339
VCM = 0VDC VCM = 0VDC
VIN = ±10VDC RL ≥ 2kΩ RL = 2kΩ VO = ±10VDC IO = 0mADC
NOTES: (1) Offset voltage, offset current, and bias current are measured with the units fully warmed up.
VCM = 0VDC VCM = 0VDC 100% tested (L) 100% tested (L) 100% tested (L)
(3) (3) (3) (3)
VIN = ±10VDC RL ≥ 2kΩ RL = 2kΩ VO = ±10VDC DC, Open Loop Gain = +1
ABSOLUTE MAXIMUM RATINGS
Supply Voltage .............................................................................. ±18VDC Internal Power Dissipation (1) ......................................................... 500mW Differential Input Voltage ............................................................... ±36VDC Input Voltage Range ..................................................................... ±18VDC Storage Temperature Range ................................... M = –65°C to +150°C P = –40°C to +85°C Operating Temperature Range ................................ M = –55°C to +125°C P = –40°C to +85°C Lead Temperature (soldering, 10s) ................................................ +300°C Output Short-Circuit Duration(3) ................................................ Continuous Junction Temperature .................................................................... +175°C NOTES: (1) Packages must be derated based on θJC = 15°C/W or θJA. (2) For supply voltages less than ±18VDC, the absolute maximum input voltage is equal to the negative supply voltage. (3) Short circuit may be to power supply common only. Rating applies to +25°C ambient. Observe dissipation limit and TJ.
INPUT OFFSET VOLTAGE(2) Input Offset Voltage Average Drift Supply Rejection BIAS CURRENT(2) Input Bias Current OFFSET CURRENT(2) Input Offset Current NOISE Voltage, fO = 10Hz 100Hz 1kHz 10kHz 20kHz fB = 10Hz to 10kHz Current, fO = 0.1Hz thru 20kHz IMPEDANCE Differential Common-Mode VOLTAGE RANGE Common-Mode Input Range Common-Mode Rejection OPEN-LOOP GAIN, DC Open-Loop Voltage Gain RATED OUTPUT Voltage Output Current Output Output Resistance Load Capacitance Stability Short Circuit Current POWER SUPPLY Rated Voltage Voltage Range, Derated Performance Current, Quiescent TEMPERATURE RANGE Specification Operating θJA
±10.5 80 95 ±11 ±5
±11.5 95 115 ±12.2 ±10 40 1000 20 ±15
±11 85 100 ±12 ±5
±11.6 96 118 Leabharlann Baidu12.6 ±10 40 1000 20 ±15
±10.2 78 90 ±11 ±5
±11 90 110 ±12 ±10 40 1000 20 ±15
®
OPA606
2
ELECTRICAL (FULL TEMPERATURE RANGE SPECIFICATIONS)
At VCC = ±15VDC and TA = TMIN to TMAX unless otherwise noted. OPA606KM PARAMETER TEMPERATURE RANGE Specification Range INPUT OFFSET VOLTAGE(1) Input Offset Voltage Average Drift Supply Rejection BIAS CURRENT(1) Input Bias Current OFFSET CURRENT(1) Input Offset Current VOLTAGE RANGE Common-Mode Input Range Common-Mode Rejection OPEN-LOOP GAIN, DC Open-Loop Voltage Gain RATED OUTPUT Voltage Output Current Output POWER SUPPLY Current, Quiescent CONDITIONS Ambient Temp. VCM = 0VDC VCC = ±10V to ±18V 80 MIN 0 ±400 ±5 98 ±13 ±158 ±14 ±10.4 78 90 ±10.5 ±5 ±11.4 92 106 ±12 ±10 6.6 10 TYP MAX +70 ±2mV 85 ±100 ±339 ±226 ±10.9 82 95 ±11.5 ±5 MIN 0 ±335 ±3 100 ±10 ±113 ±9 ±11.5 95 112 ±12.4 ±10 6.4 9.5 OPA606LM TYP MAX +70 ±750 ±5 78 ±56 ±226 ±113 ±10 75 88 ±10.4 ±5 MIN 0 ±750 ±10 95 ±18 ±181 ±23 ±10.9 88 104 ±11.8 ±10 6.6 10.5 OPA606KP TYP MAX +70 ±3.5mV UNITS °C µV µV/°C dB µV/V pA pA V dB dB V mA mA
1985 Burr-Brown Corporation
SPECIFICATIONS
ELECTRICAL
At VCC = ±15VDC and TA = +25°C unless otherwise noted. OPA606KM PARAMETER FREQUENCY RESPONSE Gain Bandwidth Full Power Response Slew Rate Settling Time(1): 0.1% 0.01% Total Harmonic Distortion CONDITIONS Small Signal 20Vp-p, RL = 2kΩ VO = ±10V, RL = 2kΩ Gain = –1, RL = 2kΩ 10V Step G = +1, 20Vp-p RL = 2kΩ f = 10kHz VCM = 0VDC TA = TMIN to TMAX VCC = ±10V to ±18V MIN 10 22 TYP 12.5 515 33 1.0 2.1 0.0035 MAX MIN 11 25 OPA606LM TYP 13 550 35 1.0 2.1 0.0035 MAX MIN 9 20 OPA606KP TYP 12 470 30 1.0 2.1 0.0035 MAX UNITS MHz kHz V/µs µs µs %
±500 ±5 80 ±32 ±10 ±5 40 28 16 13 13 1.5 2
±300 ±10 90 ±32 ±8 ±1 37 21 14 12 11 1.3 1.7 1013 || 1 1014 || 3
±3mV
±100 ±25 ±15
µV µV/°C dB µV/V pA pA nV/√Hz nV/√Hz nV/√Hz nV/√Hz nV/√Hz µVrms fA/√Hz Ω || pF Ω || pF V dB dB V mA Ω pF mA VDC
®
OPA606
Wide-Bandwidth Difet ® OPERATIONAL AMPLIFIER
FEATURES
q WIDE BANDWIDTH: 13MHz typ q HIGH SLEW RATE: 35V/µs typ q LOW BIAS CURRENT: 10pA max at TA = +25°C q LOW OFFSET VOLTAGE: 500µV max q LOW DISTORTION: 0.0035% typ at 10kHz
10
10
10
±5 IO = 0mADC Ambient Temperature KM, KP, LM Ambient Temperature 6.5
±18 9.5
±5 6.2
±18 9
±5 6.5
±18 10
VDC mA
0 –55 200
+70 +125
0 –55 200
+70 +125
0 –40 155
+70 +85
°C °C °C/W
NOTES: (1) See settling time test circuit in Figure 2. (2) Offset voltage, offset current, and bias current are measured with the units fully warmed up. (3) Sample tested–this parameter is guaranteed on L grade only.
82
±180 ±5 100 ±10 ±7 ±0.6 37 21 14 12 11 1.3 1.5 1013 || 1 1014 || 3
±1.5mV 90 ±79 ±15 ±10
±100 ±3 104 ±6 ±5 ±0.4 30 20 13 11 10.5 1.2 1.3 1013 || 1 1014 || 3
©
• Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd. • Tucson, AZ 85706 Telex: 066-6491 • FAX: (520) 889-1510 • Immediate Product Info: (800) 548-6132 PDS-598D Printed in U.S.A. July, 1995
APPLICATIONS
q OPTOELECTRONICS q DATA ACQUISITION q TEST EQUIPMENT q AUDIO AMPLIFIERS
DESCRIPTION
The OPA606 is a wide-bandwidth monolithic dielectrically-isolated FET (Difet®) operational amplifier featuring a wider bandwidth and lower bias current than BIFET® LF156A amplifiers. Bias current is specified under warmed-up and operating conditions, as opposed to a junction temperature of +25°C. Laser-trimmed thin-film resistors offer improved offset voltage and noise performance. The OPA606 is internally compensated for unity-gain stability.
1 Trim
5 Trim
7 +VCC
2 –In 3 +In
6
VOUT
Simplified Circuit
4
–VCC
Difet®; Burr-Brown Corp. BIFET®; National Semiconductor Corp. International Airport Industrial Park • Mailing Address: PO Box 11400 Tel: (520) 746-1111 • Twx: 910-952-1111 • Cable: BBRCORP •