双电源配电室高压实验操作流程

双电源配电室高压实验操作流程
1.打开配电室门，进入工作区域。

Open the distribution room door and enter the working area.
2.首先检查高压设备的工作状态，确保安全可靠。

Firstly, check the working condition of the high-voltage equipment to ensure safety and reliability.
3.关闭所有电气设备，确保配电室处于安全状态。

Turn off all electrical equipment to ensure the distribution room is in a safe condition.
4.确认所有人员已经撤离，没有人员留在配电室内。

Confirm that all personnel have evacuated and no one is left inside the distribution room.
5.穿戴好绝缘手套和绝缘鞋，做好个人防护。

Wear insulated gloves and shoes for personal protection.
6.打开高压电源开关，准备开始实验操作。

Turn on the high-voltage power switch to prepare for experimental operation.
7.检查电压表和电流表的读数是否正常，确保准确性。

Check the readings of the voltage meter and current meter to ensure accuracy.
8.确认连接线路的绝缘情况，避免漏电和短路。

Confirm the insulation of the connection lines to avoid leakage and short circuit.
9.在指定设备上进行高压实验，按照操作规程进行操作。

Conduct high-voltage experiments on the designated equipment according to the operating procedures.
10.观察实验过程中的电流和电压变化，记录实验数据。

Observe the changes in current and voltage during the experiment and record the experimental data.
11.如果发现异常情况，立即停止实验并报告相关人员。

If any abnormal situation is found, stop the experiment immediately and report to the relevant personnel.
12.实验完成后，关闭高压电源开关，切断电源。

After the experiment is completed, turn off the high-voltage power switch and disconnect the power.
13.清理实验现场，确保没有遗留物品。

Clean up the experimental site to ensure that no items are left behind.
14.关闭配电室门，离开工作区域。

Close the distribution room door and leave the working area.。