MEMORY存储芯片MAX208EWG+T中文规格书

SHDN Input Voltage ..................................(V SS - 0.3V) to +6.0V
Output Short-Circuit Duration to Either Supply .........Continuous
Continuous Input Current (IN+, IN-) .................................±10mA
Continuous Power Dissipation (T A = +70°C)
6-Pin SOT23 (derate 5.4mW/°C above +70°C) .......431.3mW
6-Pin TDFN (derate 18.2mW/°C above 70°C) ..........1454mW
8-Pin µMAX (derate 4.5mW/°C above +70°C) ............362mW 8-Pin SO (derate 5.88mW/°C above +70°C) ...............471mW 14-Pin SO (derate 8.33mW/°C above +70°C) .............667mW 14-Pin TSSOP (derate 9.1mW/°C above +70°C) ........727mW Operating Temperature Range .........................-40°C to +125°C Junction Temperature ......................................................+150°C Storage Temperature Range ............................-65°C to +150°C Lead Temperature (soldering, 10s) .................................+300°C Soldering Temperature (reflow) .......................................+260°C
(V DD = +5V, V SS = 0V, V CM = 0V, V OUT = V DD /2, R L tied to V DD /2, SHDN = V DD , T A = -40°C to +125°C, unless otherwise noted. Typical values are at T A
= +25°C.) (Notes 1, 2)
PARAMETER
SYMBOL CONDITIONS MIN TYP MAX UNITS Supply Voltage Range
V DD (Note 3) 2.7 5.5V Quiescent Supply Current Per Amplifier I D Normal mode V DD = 3V 2.2mA V DD = 5V 2.5
4.4Shutdown mode (SHDN = V SS ) (Note 2)0.01
1.0µA Input Offset Voltage V OS T A = +25°C ±70
±350µV T A = -40°C to +125°C ±750Input Offset Voltage Tempco TC VOS ±0.3
±6µV/°C Input Bias Current I B (Note 4)
±1±150pA Input Offset Current I OS (Note 4)
±1±150pA Differential Input Resistance R IN 1000GΩInput Common-Mode Voltage Range V CM Guaranteed by CMRR Test T A = +25°C
-0.2V DD - 1.6V T A = -40°C to +125°C
-0.1V DD - 1.7Common-Mode Rejection Ratio CMRR (V SS - 0.2V) ≤V CM ≤ (V DD –1.6V)T A = +25°C 90115
dB
(V SS - 0.1V) ≤V CM ≤ (V DD –1.7V)T A = -40°C to +125°C 90
Power-Supply Rejection Ratio PSRR
V DD = 2.7 to 5.5V 90
120dB Large-Signal Voltage Gain A VOL R L = 10k Ω to V DD /2; V OUT = 100mV to (V DD - 125mV)90
120dB R L = 1k Ω to V DD /2; V OUT = 200mV to (V DD - 250mV)85
110R L = 500Ω to V DD /2; V OUT = 350mV to (V DD - 500mV)85110 Integrated │ 2
DC Electrical Characteristics
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
找MEMORY 、二三极管上美光存储
(V DD = +5V, V SS = 0V, V CM = 0V, V OUT = V DD /2, R L tied to V DD /2, input noise floor of test equipment =10nV/√Hz for all distortion measurements, T A = +25°C, unless otherwise noted.)Note 1: All devices are 100% tested at T A = +25°C. Limits over temperature are guaranteed by design.
Note 2: SHDN is available on the MAX4475/MAX4488 only.Note 3: Guaranteed by the PSRR test.Note 4: Guaranteed by design.Note 5: Full-power bandwidth for unity-gain stable devices (MAX4475–MAX4478) is measured in a closed-loop gain of +2V/V to accommodate the input voltage range, V OUT = 4V P-P .
Note 6: Lowpass-filter bandwidth is 22kHz for f = 1kHz and 80kHz for f = 20kHz. Noise floor of test equipment = 10nV/√Hz .(V DD = +5V, V SS = 0V, V CM = 0V, V OUT = V DD /2, R L tied to V DD /2, SHDN = V DD , T A = +25°C.)
PARAMETER
SYMBOL CONDITIONS MIN TYP MAX UNITS Total Harmonic Distortion Plus Noise (Note 6)
THD + N V OUT = 2V P-P ,A V = +5V/V (MAX4488/MAX4489),R L = 1k Ω
to GND f = 1kHz 0.0005%f = 20kHz 0.008Capacitive-Load Stability
No sustained oscillations 200pF Gain Margin
GM 12dB Phase Margin
F M MAX4475–MAX4478, A V = +1V/V 70degrees MAX4488/MAX4489, A V = +5V/V 80Settling Time
To 0.01%, V OUT = 2V step 2µs Delay Time to Shutdown
t SH 1.5µs Enable Delay Time from Shutdown
t EN V OUT = 2.5V, V OUT settles to 0.1%10µs Power-Up Delay Time V DD = 0 to 5V step, V OUT stable to 0.1%13µs 010********-0.5 1.50.5 2.5 3.5 4.5INPUT OFFSET VOLTAGE vs. INPUT COMMON-MODE VOLTAGE INPUT COMMON-MODE VOLTAGE (V)
I N P U T O F F S E T V O L T A G E (µV
)-250-100-150-2000-5020015010050250
-50-250255075100125OFFSET VOLTAGE vs. TEMPERATURE TEMPERATURE (°C)I N P U T O F F S E T V O L T A G E (
µV )4
2
1086121416
18-50-30-20-40-1001020304050
INPUT OFFSET VOLTAGE DISTRIBUTION
V OS (µV)P E R C E N T A G E O F U N I T S (%)0
Integrated │ 4MAX4475–MAX4478/
MAX4488/MAX4489
SOT23, Low-Noise, Low-Distortion, Wide-Band, Rail-to-Rail Op Amps
Typical Operating Characteristics
AC Electrical Characteristics。