MSM27C3252CZ资料

1
¡ The MSM27C3252CZ is a 32Mbit electrically Programmable Read-Only Memory with page mode.
Its configuration can be electrically switched between 2,097,152 word x 16bit and 4,194,304 word x 8bit. The MSM27C3252CZ operates on a single +5V power supply and is TTL compatible. The MSM27C3252CZ provides Page mode which can greatly reduce the read access time. Since the MSM27C3252CZ operates asynchronously , external clocks are not required , making this device easy-to-use. The MSM27C3252CZ is suitable as large-capacity fixed memory for microcomputers and data terminals. It is manufactured using a CMOS double silicon gate technology and is offered in 44-pin SOP or 48-pin TSOP packages.
1A
MSM27C3252CZ
2,097,152-Word x 16-Bit or 4,194,304-Word x 8-Bit
8-Word x 16-Bit or 16-Word x 8-Bit Page Mode One Time PROM
DESCRIPTION
FEATURES
• 2,097,152 word x 16bit / 4,194,304 word x 8bit electrically switchable configuration • Single +5V power supply • Access time 100ns
Page mode access time 50ns • Input / Output TTL compatible • Three-state output • Packages
44-pin plastic SOP (SOP44-P-600-1.27-K)
48-pin plastic TSOP (TSOP II 48-P-550-0.80-K)
Semiconductor
2
PIN CONFIGURATION (TOP VIEW)
MSM27C3252CZ
48-pin TSOP
44-pin SOP
PIN NAMES FUNCTIONS
D15/A-1Data output / Address input
A0 - A20Address input D0 - D14Data output CE OE Output enable
V CC Power supply voltage BYTE/V PP
Mode switch / Program power supply voltage NC
Non connection
Chip enable V SS GND
MSM27C3252CZ
BLOCK DIAGRAM
A-1
3
4
Operating temperature under bias Storage temperature Input voltage Output voltage
Power supply voltage
Program power supply voltage Power dissipation per package
Parameter
Symbol Topr Unit
Value Condition
RECOMMENDED OPERATING CONDITIONS FOR READ
V CC power supply voltage V PP power supply voltage Input "H" level Input "L" level
Parameter
Symbol V CC Unit 5.5Typ.4.5Condition
T stg V I V O V CC V PP P D
0 to 70-55 to 125V -0.5 to V CC + 0.5V -0.5 to V CC + 0.5
V -0.5 to 7V -0.5 to 12.5
W
1.0
-relative to V SS (Ta=0 to 70°C)
Min.Max.V V CC +0.5-0.5-V V CC +0.52.2-V 0.8
-0.5
-V
V PP V IH V IL
V CC =4.5V - 5.5V
Voltage is relative to Vss
ABSOLUTE MAXIMUM RATINGS
--MSM27C3252CZ
°C °C
ns 0.45
-5
ELECTRICAL CHARACTERISTICS (Read operation)
DC Characteristics
Input leakage current Output leakage current V CC power supply current (Standby)
V CC power supply current (Read)
V PP power supply current Parameter
Symbol Unit Condition (V CC =5V ±0.5V, Ta=0 to 70°C)
Input "H" level Input "L" level Output "H" level Output "L" level
Voltage is relative to Vss 10Typ.-Min.Max.I LO I CS1I CS2I CCA µA -10-µA -50-µA -CE=V CC 1-CE=V IH
100-mA tc=100ns
--I PP V IH V IL V OH V OL
10µA V PP =V CC
V CC +0.52.2V -0.8-0.5V --2.4V I OH =-400µA -V
I OL =2.1mA
---CE=V IL , OE=V IH V I =0 to Vcc V O =0 to Vcc MSM27C3252CZ
mA -400
100pF (including jig capacitance)
1.7V
Output
AC Characteristics
Address access time CE access time OE access time Output disable time Parameter
Symbol T ACC Unit -Condition
(V CC =5V ±0.5V, Ta=0 to 70°C)
Min.Max.T CE ns CE=OE=V IL -ns OE=V IL 50-ns CE=V IL 400ns OE=V IL 350ns -0
T OE T OH
CE=V IL CE=OE=V IL
Output hold time
100100T CHZ T OHZ Random access cycle time T C 100ns --0V/3V 0.8V/2.0V
1TTL gate + 100pF 0.8V/2.0V Measurement conditions
Input signal level
Input timing reference level Output load
Output timing reference level
120-50--50ns ns ns
Page set up time Page access cycle time Page access time T PSET T PC T PAC --NOTE(1)
NOTE(1) T PSET is defined as the end of either CE trailing edge or address transition in random access term until the first page address transition. I LI -
MSM27C3252CZ
A0 - A2 (Word mode)A-1 - A2 (Byte mode)
6
CE
OE
DOUT
CE
OE
TIMING CHART
NORMAL MODE READ CYCLE
PAGE MODE READ CYCLE
DOUT
A3 - A20
7
ELECTRICAL CHARACTERISTICS (Programming operation)
DC Characteristics
Input leakage current
V PP power supply current (Program)V CC power supply current Parameter
Symbol I LI Unit 10Typ.-Condition (Ta=25°C ±5°C)
Min.Max.Input "L" level I PP2I CC V IH V IL µA -V I =V CC +0.5V 50-mA -CE=V IL
100-mA --V CC +0.52.2V -0.8-0.5V --11.5-Voltage is relative to Vss
Input "H" level V OH -2.4V I OH =-400µA -Output "H" level V OL 0.45-V I OL =2.1mA
-Output "L" level V PP 11.7511.25V -Program voltage
V CC power supply voltage V CC
6.5
6.0
V
6.25
-AC Characteristics
Address set-up time OE set-up time Data set-up time Parameter
Symbol T AS Unit -Typ.2Condition
Min.Max.Data hold time
T OES T DS T AH T DH µs --2µs --2µs ---0µs --2µs ---Address hold time T DFP 1300ns -Output float delay from OE T VS -2µs -V PP voltage set-up time Program pulse width T PW 2723µs 25-Data valid from OE
T OE
150
-ns
------(V cc =6.25V ±0.25V,V pp =11.5V ±0.25V,Ta=25°C ±5°C)
MSM27C3252CZ
MSM27C3252CZ Programming Waveform
8
MSM27C3252CZ
High Speed Programming Algorithm ( I )
9
MSM27C3252CZ High Speed Programming Algorithm ( II )
10
Semiconductor
NOTICE
The information contained herein can change without notice owing to product and/or technical im-provements. Before using the product, please make sure that the information being referred to is up-to-date.
The outline of action and examples for application circuits described herein have been chosen as an explanation for the standard action and performance of the product. When planning to use the product, please ensure that the external conditions are reflected in the actual circuit, assembly, and program designs.
When designing your product, please use our product below the specified maximum ratings and within the specified operating ranges including, but not limited to, operating voltage, power dissipation, and operating temperature.
Oki assumes no responsibility or liability whatsoever for any failure or unusual or unexpected opera-tion resulting from misuse, neglect, improper installation, repair, alteration or accident, improper han-dling, or unusual physical or electrical stress including, but not limited to, exposure to parameters be-yond the specified maximum ratings or operation outside the specified operating range.
Neither indemnity against nor license of a third party’s industrial and intellectual property right, etc. is granted by us in connection with the use of the product and/or the information and drawings contained herein. No responsibility is assumed by us for any infringement of a third party’s right which may result from the use thereof.
The products listed in this document are intended for use in general electronics equipment for commer-cial applications (e.g., office automation, communication equipment, measurement equipment, consumer electronics, etc.). These products are not authorized for use in any system orapplication that requires special or enhanced quality and reliability characteristics nor in any system or application where the failure of such system or application may result in the loss or damage of property, or death or injury to humans. Such applications include, but are not limited to,traffic and automotive equipment, safety de-vices, aerospace equipment, nuclear power control, medical equipment, and life-support systems. Certain products in this document may need government approval before they can be exported to par-ticular countries. The purchaser assumes the responsibility of determining the legality of export of these products and will take appropriate and necessary steps at their own expense for these.
No part of the contents cotained herein may be reprinted or reproduced without our prior permission. All brand, company and product names are the trademarks or registered trademarks of their respective owners.
Copyright 1998 Oki Electric Industry Co., Ltd.
ADDRESSES & SEMICONDUCTOR WEB SITES
OKI Electric Industry Co., Ltd.
OKI Electric Industry Co., Ltd.,
Device Business Group,
10-3, Shibaura, 4-chome,
Minato-ku, Tokyo 108, Japan,
Tel.: +81-(0)3-5445-6327,
Fax.: +81-(0)3-5445-6328,
http://www.oki.co.jp/OKI/DBG/english/index.htm
(NOTE: URL is case sensitive)
OKI Semiconductor Group
OKI Semiconductor Group,
785 North Mary Avenue,
Sunnyvale, CA 94086, U.S.A.,
Tel.: +1-408-720-1900,
Fax.: +1-408-720-1918,
/
OKI Electric Europe GmbH
OKI Electric Europe GmbH,
Head Office Europe,
Hellersbergstrasse 2,
D-41460 Neuss, Germany,
Tel: +49-2131-15960,
Fax: +49-2131-103539,
http://www.oki-europe.de/
OKI Electronics (Hong Kong) Ltd.
OKI Electronics (Hong Kong) Ltd.,
Suite 1901-1&19, Tower 3,
China Hong Kong City,
33 Canton Road, Tsimshatsui,
Kowloon, Hong Kong,
Tel.: +852-2-736-2336,
Fax.: +852-2-736-2395
OKI Semiconductor (Asia) Pte. Ltd.
OKI Semiconductor (Asia) Pte. Ltd.,
78 Shenton Way 09-01,
Singapore 0207,
Tel.: +65-221-3722,
Fax.: +65-323-5376
OKI Semiconductor (Asia) Pte. Ltd.
OKI Semiconductor (Asia) Pte. Ltd.,
Taipei Branch,
7th Fl. No.260, Tun Hwa North Road,
Taipei, Taiwan, R.O.C.,
Sumitomo-Flysun Building,
Tel.: +886-2-2719-2561,
Fax.: +886-2-2715-2892
.tw/
People To People Technology。