单级稀释不宜超过100 倍的原因

单级稀释不宜超过100 倍的原因
1.单级稀释超过100倍会导致溶液过于稀释，影响实验结果。

Excessive dilution of more than 100 times will lead to excessively dilute solution, affecting the experimental results.
2.过大的稀释倍数会使溶液中的待测物质浓度过低，难以准确测量。

Excessive dilution would cause the concentration of the substance in the solution to be too low to accurately measure.
3.实验中需要保持溶液的一定浓度，以确保实验的准确性和可重
复性。

It is necessary to maintain a certain concentration of
the solution in the experiment to ensure the accuracy and repeatability of the experiment.
4.过大的稀释倍数可能导致实验过程中出现误差，影响结果的可
靠性。

Excessive dilution may lead to errors in the experimental process, affecting the reliability of the results.
5.稀释倍数过大会导致溶液中其它物质的浓度变得可以忽略不计，造成实验结果的失真。

Excessive dilution would make the concentration of other substances in the solution negligible, causing distortion of the experimental results.
6.实验中需要平衡溶液的稀释程度和待测物质的浓度，以获得准
确可靠的数据。

It is necessary to balance the dilution of the solution and the concentration of the substance to obtain accurate and reliable data in the experiment.
7.只有在稀释倍数合适的情况下才能确保实验的准确性和可靠性。

Only when the dilution is appropriate can the accuracy and reliability of the experiment be ensured.
8.超过100倍的稀释会导致溶液中的待测物质浓度过低，无法得到符合要求的测量结果。

Dilution of more than 100 times would lead to excessively low concentration of the substance in the solution, resulting in measurement results that do not meet the requirements.
9.稀释倍数过大会加大误差，使实验结果偏离真实值。

Excessive dilution would increase the error, deviating the experimental results from the true value.
10.单级稀释不宜超过100倍，可避免实验过程中的不确定因素。

The single-level dilution should not exceed 100 times, which can avoid uncertainties in the experimental process.
11.过大的稀释倍数可能导致溶液的pH值发生变化，影响实验结果的可比性。

Excessive dilution may cause a change in the pH of the solution, affecting the comparability of the experimental results.
12.稀释倍数过大会使实验中的微量物质变得难以检测。

Excessive dilution would make trace substances in the experiment difficult to detect.
13.实验中过大的稀释倍数可能使溶液中的离子浓度降低，从而影响实验结果的准确度。

Excessive dilution in the experiment may reduce the ion concentration in the solution, thereby affecting the accuracy of the experimental results.
14.单级稀释不宜超过100倍，可以保持溶液中物质的相对浓度。

Single-level dilution should not exceed 100 times to maintain the relative concentration of substances in the solution.
15.稀释倍数过大会增加实验中的操作难度。

Excessive dilution would increase the operational difficulty in the experiment.
16.过大的稀释倍数会降低溶液的稳定性，可能导致化学反应发生变化。

Excessive dilution would reduce the stability of the solution, possibly causing changes in chemical reactions.
17.实验中的稀释倍数应当根据具体情况进行合理选择。

The dilution ratio in the experiment should be selected reasonably based on the specific situation.
18.超过100倍的稀释降低了溶液中待测物质的浓度，从而影响了实验结果的准确性。

Dilution of more than 100 times reduces the concentration of the substance in the solution, thereby affecting the accuracy of the experimental results.
19.实验中适当的稀释倍数有助于保持溶液中物质的活性。

Appropriate dilution ratio in the experiment helps to maintain the activity of substances in the solution.
20.过大的稀释倍数会提高实验中的检测限。

Excessive dilution would increase the detection limit in the experiment.
21.单级稀释不宜超过100倍，以免对实验进行多次稀释。

Single-level dilution should not exceed 100 times to avoid multiple dilutions in the experiment.
22.稀释倍数快速增加会导致溶液中的杂质和干扰物质被稀释，难以检测。

The rapid increase in dilution ratio would lead to the dilution of impurities and interfering substances in the solution, making it difficult to detect.
23.过大的稀释倍数会降低实验的灵敏度和可检测性。

Excessive dilution would reduce the sensitivity and detectability of the experiment.
24.单级稀释过大会使实验中所需要的稀释管数增加，增加了操作复杂度。

Excessive single-level dilution would increase the number of dilution tubes needed in the experiment, increasing the complexity of the operation.
25.超过100倍的稀释可能导致溶液中微量物质的丢失。

Dilution of more than 100 times may lead to the loss of trace substances in the solution.
26.实验中合适的稀释倍数可以使待测物质达到最佳检测浓度。

Appropriate dilution ratio in the experiment can achieve the optimal detection concentration of the substance.
27.过大的稀释倍数可能导致实验中的目标成分被稀释到难以检测的程度。

Excessive dilution may lead to the target component in the experiment being diluted to an undetectable extent.
28.单级稀释不宜超过100倍，以避免溶液中未知成分的影响。

Single-level dilution should not exceed 100 times to
avoid the influence of unknown components in the solution.
29.稀释倍数过大会使实验中的目标成分稀释到不利于测量的程度。

Excessive dilution would dilute the target component in
the experiment to an extent that is not conducive to measurement.
30.实验中如果稀释倍数过大，可能导致实验结果出现偏差。

If the dilution ratio is too large in the experiment, it may lead to deviation in the experimental results.
31.单级稀释的最大倍数为100，超过该倍数可能引入额外的误差。

The maximum dilution ratio for single-level dilution is 100, exceeding this ratio may introduce additional errors.
32.过大的稀释倍数可能使溶液中的微量物质变得难以稳定。

Excessive dilution would make trace substances in the solution difficult to stabilize.
33.稀释倍数过大可能使实验中的目标成分被稀释到检测仪器的灵
敏度之外。

Excessive dilution may dilute the target component in the experiment beyond the sensitivity of the detection instrument.
34.单级稀释倍数超过100可能导致在稀释过程中出现误差积累。

A dilution ratio exceeding 100 for single-level dilution may lead to error accumulation in the dilution process.
35.稀释倍数过大可能导致实验中的目标成分浓度低于检测仪器的
最低检测限。

Excessive dilution may lead to a concentration of the target component in the experiment lower than the minimum detection limit of the detection instrument.
36.单级稀释倍数不宜过大，以确保实验结果的可比性和准确性。

The dilution ratio for single-level dilution should not
be too large to ensure the comparability and accuracy of the experimental results.
37.稀释倍数过大可能使实验中的目标成分变得无法检测。

Excessive dilution may make the target component in the experiment undetectable.
38.单级稀释过大容易造成实验误差的积累。

Excessive single-level dilution is prone to accumulate experimental errors.
39.过大的稀释倍数会使实验中的操作变得繁琐。

Excessive dilution would make the operation in the experiment cumbersome.
40.单级稀释超过100倍可能导致实验中待测物质的浓度低于所需检测范围。

Excessive single-level dilution exceeding 100 times may lead to a concentration of the substance being lower than the required detection range in the experiment.
41.稀释倍数过大可能使实验结果失真。

Excessive dilution may distort the experimental results.
42.单级稀释不宜超过100倍，以确保实验中目标成分的浓度符合检测要求。

Single-level dilution should not exceed 100 times to ensure that the concentration of the target component in the experiment meets the detection requirements.
43.稀释倍数过大容易引入额外的操作误差。

Excessive dilution easily introduces additional operational errors.
44.单级稀释超过100倍会增加实验的难度。

Excessive single-level dilution exceeding 100 times would increase the difficulty of the experiment.
45.稀释倍数过大会降低实验的可靠性。

Excessive dilution would reduce the reliability of the experiment.
46.单级稀释不宜超过100倍，以确保实验结果的可重复性。

Single-level dilution should not exceed 100 times to ensure the repeatability of the experimental results.
47.过大的稀释倍数可能导致实验结果出现误差。

Excessive dilution may lead to errors in the experimental results.
48.稀释倍数超过100会使实验中的目标成分浓度过低，难以稳定。

Dilution of more than 100 times would make the concentration of the target component in the experiment too
low to stabilize.
49.单级稀释不宜超过100倍，避免对待测物质进行过度稀释。

Single-level dilution should not exceed 100 times to
avoid excessive dilution of the substance being tested.
50.稀释倍数过大会使实验中的目标成分浓度降低，影响测量结果
的准确性。

Excessive dilution would reduce the concentration of the target component in the experiment, affecting the accuracy of the measurement results.
51.实验中适当的稀释倍数有助于提高实验的效率。

Appropriate dilution ratio in the experiment helps improve the efficiency of the experiment.
52.如果稀释倍数过大，实验中的目标成分可能变得无法检测。

If the dilution ratio is too large, the target component in the experiment may become undetectable.
53.单级稀释不宜超过100倍，以确保实验中的目标成分可以稳定检测。

Single-level dilution should not exceed 100 times to ensure that the target component in the experiment can be stably detected.。