Hi3516A H.265核心开发板手册

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 55128k/55128k available, 10408k reserved, 0K highmem
Virtual kernel memory layout:
.bss : 0xc0594924 - 0xc09918e0 (4084 kB)
SLUB: Genslabs=11, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:128
sched_clock: 32 bits at 49MHz, resolution 20ns, wraps every 86767ms
附核心板启动信息：
U-Boot 2010.06 (Nov 07 2014 - 17:58:56) NAND: Check nand flash controller v610. found Special NAND id table Version 1.36 Nand ID: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 No NAND device found!!! 0 MiB Check spi flash controller v350... Found Spi(cs1) ID: 0xC2 0x20 0x18 0xC2 0x20 0x18 Spi(cs1): Block:64KB Chip:16MB Name:"MX25L128XX" In: serial Out: serial Err: serial Hit any key to stop autoboot: 0 16384 KiB hi_sfc at 0:0 is now current device
我们支持您设计自己的外设板与 Hi3516A 核心板配合工作，您也可以选配 本店的外设板
如有定制需求，请联系 QQ 2768494362 或 Email: 2768494362@ Features
Hi3516A: Hi3516ARBCV100 DDR3: 1GByte SPI FLASH:128Mbit UART: TTL SD CARD: MicroSD Socket VIDEO INPUT CONNECTOR:
− 8-/10-/12-/14-bit RGB Bayer DC − BT.601, BT.656, or BT.1120 VI interface − HD CMOS sensor parallel interface (Upto 5 megapixels) THREE PERIPHERAL EXTENSION CONNECTOR: − USB2.0 − RGMII − SPI − SDIO − Video Output − Analog Audio − I2S − UART − Reset Out, Power SIZE: 51mm X 84mm
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
vmalloc : 0xc4800000 - 0xff000000 ( 936 MB)
lowmem : 0xc0000000 - 0xc4000000 ( 64 MB)
modules : 0xbf000000 - 0xc0000000 ( 16 MB)
.text : 0xc0008000 - 0xc0539000 (5316 kB)
.init : 0xc0539000 - 0xc055a67c ( 134 kB)
.data : 0xc055c000 - 0xc0594900 ( 227 kB)
Hi3516A H.265 Encoder Board
Hi3516A 核心板适合于音视频、监控、机器视觉、图像处理等系统原型快 速搭建，用户专注于核心算法开发
核心板全部采用机器贴片焊接以确保质量
板内已烧录 UBOOT，Linux kernel 和文件系统，并提供 BIN 文件 核心板上已烧录 USB，以太网、SPI、SDIO、UART、I2C、802.11 等驱动 提供 Hi3516A 最新视频开发包 SDK 及源码 提供核心板原理图
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) squashfs: version 4.0 (2009/01/31) Phillip Lougher NFS: Registering the id_resolver key type jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc. fuse init (API version 7.18) SGI XFS with security attributes, large block/inode numbers, no debug enabled msgmni has been set to 107 Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254) io scheduler noop registered io scheduler deadline registered (default) io scheduler cfq registered brd: module loaded loop: module loaded Spi id table Version 1.22 Spi(cs1) ID: 0xC2 0x20 0x18 0xC2 0x20 0x18 SPI nor flash boot mode is 3 Bytes Spi(cs1): Block:64KB Chip:16MB Name:"MX25L128XX" spi size: 16MB chip num: 1 3 cmdlinepart partitions found on MTD device hi_sfc 3 cmdlinepart partitions found on MTD device hi_sfc Creating 3 MTD partitions on "hi_sfc": 0x000000000000-0x000000100000 : "boot" 0x000000100000-0x000000400000 : "kernel" 0x000000400000-0x000001000000 : "rootfs" Found Nand Flash Controller V610. Nand ID: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 No NAND device found Higmac dma_sg_phy: 0x83a80000 higmac_mdio_bus: probed PHY mdio0:01 not found
mtdparts=hi_sfc:1M(boot),3M(kernel),12M(rootfs)
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
OK
Starting kernel ...ቤተ መጻሕፍቲ ባይዱ
Uncompressing Linux... done, booting the kernel. Booting Linux on physical CPU 0 Linux version 3.4.35 (pub@BVT-SDK-SERVER3) (gcc version 4.8.3 20131202 (prerelease) (Hisilicon_v300) ) #1 Fri Nov 7 17:59:57 HKT 2014 CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=10c53c7d CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache Machine: hi3516a
## Booting kernel from Legacy Image at 82000000 ... Image Name: Linux-3.4.35 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2957704 Bytes = 2.8 MiB Load Address: 80008000 Entry Point: 80008000 Loading Kernel Image ... OK
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: mem=64M console=ttyAMA0,115200 root=/dev/mtdblock2 rootfstype=jffs2
per task-struct memory footprint: 1152 bytes
Calibrating delay loop... 1196.85 BogoMIPS (lpj=5984256)
pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 Initializing cgroup subsys freezer CPU: Testing write buffer coherency: ok Setting up static identity map for 0x8040fb70 - 0x8040fbc8 NET: Registered protocol family 16 Serial: AMBA PL011 UART driver uart:0: ttyAMA0 at MMIO 0x20080000 (irq = 40) is a PL011 rev2 console [ttyAMA0] enabled uart:1: ttyAMA1 at MMIO 0x20090000 (irq = 41) is a PL011 rev2 bio: create slab <bio-0> at 0 SCSI subsystem initialized hi-spi-master hi-spi-master.0: hi_spi_probe: hisilicon soc spi host driver loaded for bus spi-0 with 1 chip select slaves attached hi-spi-master hi-spi-master.1: hi_spi_probe: hisilicon soc spi host driver loaded for bus spi-1 with 3 chip select slaves attached usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Switching to clocksource timer0 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 4, 73728 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP: reno registered UDP hash table entries: 64 (order: 0, 5120 bytes) UDP-Lite hash table entries: 64 (order: 0, 5120 bytes) NET: Registered protocol family 1 RPC: Registered named UNIX socket transport module. RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. VFS: Disk quotas dquot_6.5.2
Console: colour dummy device 80x30
Lock dependency validator: Copyright (c) 2006 Red Hat, Inc., Ingo Molnar
... MAX_LOCKDEP_SUBCLASSES: 8
... MAX_LOCK_DEPTH:
48
... MAX_LOCKDEP_KEYS:
8191
... CLASSHASH_SIZE:
4096
... MAX_LOCKDEP_ENTRIES:
16384
... MAX_LOCKDEP_CHAINS:
32768
... CHAINHASH_SIZE:
16384
memory used by lock dependency info: 3679 kB