医气紫铜管系统的充氮保护焊接流程

医气紫铜管系统的充氮保护焊接流程
1.准备好医用紫铜管系统和充氮保护焊接设备。

Prepare the medical purple copper tube system and the nitrogen protection welding equipment.
2.清洁和打磨要焊接的管道，确保表面光滑干净。

Clean and polish the pipes to be welded, ensuring a
smooth and clean surface.
3.在焊接区域周围设置气体保护罩，保证焊接过程中氮气的环境。

Set up a gas protection cover around the welding area to ensure a nitrogen environment during the welding process.
4.开启氮气瓶，调节氮气流量并连接到焊接设备。

Open the nitrogen cylinder, adjust the nitrogen flow, and connect it to the welding equipment.
5.打开焊接设备，预热焊枪并调整焊接参数。

Turn on the welding equipment, preheat the welding gun, and adjust the welding parameters.
6.开始焊接，保持稳定的焊接动作和速度。

Start welding, maintaining a steady welding motion and speed.
7.确保焊接过程中氮气环境不受外界干扰。

Ensure that the nitrogen environment is not disturbed during the welding process.
8.检查焊接质量，确保焊缝均匀牢固。

Check the welding quality to ensure that the weld is even and strong.
9.关闭焊接设备，并等待焊接区域冷却。

Turn off the welding equipment and wait for the welding area to cool down.
10.断开氮气瓶，并拆除气体保护罩。

Disconnect the nitrogen cylinder and remove the gas protection cover.
11.清理焊接区域，移除焊接残渣和杂物。

Clean the welding area, removing welding residues and debris.
12.检查焊接区域，确保没有氮气泄漏和其他安全隐患。

Inspect the welding area to ensure that there are no nitrogen leaks or other safety hazards.
13.保持焊接区域通风，排除残留氮气。

Maintain ventilation in the welding area to remove any remaining nitrogen.
14.确认整个充氮保护焊接流程结束。

Confirm the completion of the entire nitrogen protection welding process.。