水利水电专业毕业论文 文献翻译 坝(可编辑)

水利水电专业毕业论文文献翻译坝（可编辑）水利水电专业毕业论文文献翻译坝Dam The first dam for which there are reliable records was build or the Nile River sometime before 4000 B.C. It was used to divert the Nile and provide a site for the ancient city of Memphis .The oldest dam still in use is the Almanza Dam in Spain, which was constructed in the sixteenth century. With the passage of time,materials and methods of construction have improved. Making possible the erection of such large dams as the Nurek Dam, which is being constructed in the U.S.S.R. on the vaksh River near the border of Afghanistan. This dam will be 1017ft333m high, of earth and rock fill. The failure of a dam may cause serious loss of life and property; consequently, the design and maintenance of dams are commonly under government surveillance. In the United States over 30,000 dams are under the control of state authorities. The 1972 Federal Dams Safety Act PL92-367requires periodic inspections of dams by qualified experts. The failure of the Teton Dam in Idaho in June 1976 added to the concern for dam safety in the United States.1 Type of DamsDams are classified on the type and materials of construction, as gravity, arch, buttress ,and earth .The first three types are usually constructed of concrete. A gravity dam depends on its own weight for stability and it usually straight in plan although sometimes slightly curved. Arch dams transmit most of the horizontal thrust of the waterbehind them to the abutments by arch action and have thinner cross sections than comparable gravity dams. Arch dams can be used only in narrow canyons where the walls are capable of withstanding the thrust produced by the arch action. The simplest of the many types of buttress dams is the slab type, which consists of sloping flat slabs supported at intervals by buttresses. Earth dams are embankments of rock or earth with provision for controlling seepage by means of dam may be includedin a single structure. Curved dams may combine both gravity and arch action to achieve stability. Long dams often have a concrete river section containing spillway and sluice gates and earth or rock-fill wing dams for the remainder of their length The selection of the best type of dam for a given site is a problem in both engineering feasibility and cost. Feasibility is governed by topography, geology and climate. For example, because concrete spalls when subjected to alternate freezing and thawing, arch and buttress dams with thin concrete section are sometimes avoided in areas subject to extreme cold. The relative cost of the various types of dams depends mainly on the availability of construction materials near the site and the accessibility of transportation facilities. Dams are sometimes built in stages with the second or late stages constructed adecade or longer after the first stage The height of a dam isdefined as the difference in elevation between the roadway, or spillway crest, and the lowest part of the excavated foundation. However, figures quoted for heights of dams are often determined in other ways.Frequently the height is taken as the net height is taken as the net height above the old riverbed.2.Forced on dams A dam must be relatively impervious to water and capable of resisting the forces acting on it. The most important of these forces are gravity weight of dam , hydrostatic pressure, uplift, ice pressure, and earthquake forces are transmitted to the foundation and abutments of the dam, which react against the dam with an equal and opposite force, the foundation reaction. The effect of hydrostatic forces caused by water flowing over the dam may require consideration in special cases The weight of a dam is the product of its volume and the specific weight of the material. The line of action of dynamic force passes through the center of mass of the cross section. Hydrostatic force may act on both the upstream and downstream faces of the dam. The horizontal component of the hydrostatic force is the force or unit width of dam it is Where r is the specific weight of water and h is the depth of water .The line of action of this force is h/3 above the base of the dam .The vertical component of the hydrostatic force is equal to the weigh of water vertically above the face of the dam and passes through the center ofgravity of this volume of water Water under pressure inevitablyfinds its way between the dam And its foundation and creates uplift pressures. The magnitude of the uplift force depends on the character of the foundation and the construction methods. It is often assumed that the uplift pressure varies linearly from full hydrostatic pressure atthe upstream face heelto full tail-water pressure at the downstream face toe.For this assumption the uplift force U is Urh1+h2t/2Where t is the base thickness of the dam and h1and h2 are the water depths at the heel and toe of the dam,respectively. The uplift force will act through the center of area of the pressure trapezoid Actual measurements on dams indicate that the uplift force is much less than that given byEq.2Various assumption have been made regarding the distribution ofuplift pressures.The ////0>. of Reclamation sometimes assumes that the uplift pressure on gravity dams varies linearly from two-thirds of full uplift at the heel to zero at the toe. Drains are usually provided near the heel of the dam to permit the escape of seepage water and relieve uplift译文:坝据可靠记载,世界上第一座坝是公元前4000年以前在尼罗河上修建的。