无菌室灭菌柜的异常处理流程

无菌室灭菌柜的异常处理流程英文回答：
UVC Sterilization Cabinet Malfunction Troubleshooting Procedure.
1. Visual Inspection.
Check if the UV lamps are lit. If not, replace the lamps.
Inspect the door seals for damage and ensure they are properly closed.
Make sure the chamber is free of debris and materials that could block UV light.
2. Electrical Inspection.
Check the power supply to the cabinet.
Verify that the fuse is not blown.
Inspect the electrical wiring for damage or loose connections.
3. Control Panel Inspection.
Check if the display panel is showing any error messages.
Verify that the timer is set correctly.
Ensure that the temperature and humidity settings are within the recommended range.
4. UV Sensor Inspection.
Calibrate the UV sensor according to the manufacturer's instructions.
Check if the sensor is dirty or blocked.
Replace the sensor if necessary.
5. Cycle Completion and Validation.
After the sterilization cycle is complete, check if the cycle indicator light is on.
Perform biological or chemical indicators to validate the effectiveness of the sterilization.
6. Maintenance and Cleaning.
Regularly clean the chamber and door seals with a disinfectant solution.
Replace the UV lamps every 12,000 hours of operation.
Calibrate the UV sensor annually.
If the above steps do not resolve the issue, contact a qualified technician for further troubleshooting.
中文回答：
无菌室灭菌柜异常处理流程。

1. 视觉检查。

检查紫外线灯是否亮。

如果不亮，更换灯。

检查门封是否有损坏，确保其正确关闭。

确保腔室中没有碎屑和材料，以免阻挡紫外线。

2. 电气检查。

检查灭菌柜的电源。

确认保险丝没有烧断。

检查电线是否有损坏或连接松动。

3. 控制面板检查。

检查显示屏是否显示任何错误消息。

验证计时器设置正确。

确保温度和湿度设置在推荐范围内。

4. 紫外线传感器检查。

按照制造商的说明校准紫外线传感器。

检查传感器是否脏污或堵塞。

必要时更换传感器。

5. 周期完成和验证。

灭菌周期完成后，检查周期指示灯是否亮起。

执行生物或化学指示剂以验证灭菌的有效性。

6. 维护和清洁。

定期用消毒液清洁腔室和门封。

每运行 12,000 小时更换一次紫外线灯。

每年校准紫外线传感器。

如果上述步骤无法解决问题，请联系合格的技术人员进行进一步故障排除。