澳州汽车设计相关(ADR)法规
合集下载
- 1、下载文档前请自行甄别文档内容的完整性,平台不提供额外的编辑、内容补充、找答案等附加服务。
- 2、"仅部分预览"的文档,不可在线预览部分如存在完整性等问题,可反馈申请退款(可完整预览的文档不适用该条件!)。
- 3、如文档侵犯您的权益,请联系客服反馈,我们会尽快为您处理(人工客服工作时间:9:00-18:30)。
angles of geometric visibility to the propagation of light from any part of the apparent surface of
the lamp observed from infinity.
所有灯具安装时要对称
A.5 A.5.5.1
angle in which the apparent surface of the lamp must be visible. That field of the solid angle is
determined by the segments of the sphere of which the centre coincides with the centre of reference of the lamp and the equator is parallel with the ground. These segments are
法实现则改为
侧反射片
1500
250
Side Reflex Reflector (Non-triangular)
or 1500 if 900 not
possible)
后转向灯 Rear Direction Indicator
1500
350
刹车灯 Stop Lamp
1500
350
后示宽灯 Rr. Position Lamp
YN
determined in relation to the axis of reference. The horizontal angles S correspond to the
longitude and the vertical angles α to the latitude. There must be no obstacle on the inside of the
In the absence of specific instructions lamps constituting a pair shall: be fitted to the vehicle symmetrically in relation to the median longitudinal plane (this estimate to Y N be based on the exterior geometrical form of the lamp and not on the edge of its illuminating surface referred to in paragraph 2.9.);
1200
500
600
400
YN
近光灯 Dipped-beam Head Lamp
1200
500
600
400
YN
倒车灯 Reverse Lamp
1200
250
YN
前转向灯 Fr. Direction-Indicator Lamp
1500
350
600
400
YN
前示宽灯 Fr. Position Lamp
YN
paragraph 2.7. in a forward direction and no white light which could give rise to confusion, other
them
400
YN
日行灯 Daytime Running Lamp
牌照灯 Number Plate Lamp 条款
1500
250
600
400
YN
能照亮牌照表 能照亮牌照 能照亮牌照
面
表面
表面
能照亮牌照表面
Y
N
要求
能见度 Visibility 所有灯具表面都不能被车体任何部件阻挡
A.2.13
"Angles of geometric visibility" means the angles which determine the field of the minimum solid
前顶示宽灯 End-Outline Marker Lamp
侧转向灯 Side Direction Indicator
1500
350
装在前挡风玻 璃上方
Above top of windscreen
1500
500
600
400
YN
400
YN
1800 (到车前端 to the front end)
Y
N
900 (如果 900 无
1500
350
后顶示宽灯 Rear End-Outline Marker Lamp
尽量高
High as possible
1 个距车前小于 3 米, 1 个在车的中间三分 之一处, 1 个在距车最 后小于 1 米处(如距 最大间距 3m 离不够,适情况加 Y N
装)
1 <3m from front, 1 in middle third, 1 <1m from rear, max 3m between
them
600
400
YN
600
400
YN
600
400
YN
400
YN
Page 1 of 13
侧标志灯 Side Marker Lamp
1500
600
后反射片
Rear Reflex reflector (Non-triangular)
900
250
1 个在车的 1/3 且
司机椅后方, 1 个在
车的中间三分之一
处, 1 个在距车最后
小于 300mm 处(如
距离不够,适情况
加装)
YN
1 inside first 1/3 but
not forward of rear
part of driver’s seat. 1
in middle third, 1
<300mm from rear,
max 3m between
从车前方不能看到有红光溢出,从车后方不能看到有白光溢出(已出现过后牌照 灯白光溢出情况,请多加注意)
A.5.10 A.5.11
No red light which could give rise to confusion shall be emitted from a lamp as defined in
ADR 13/00 –灯具安装
Installation of Lighting and Light Signalling Devices
要求
类型
离地高度 Height(mm)
间距 Apart(最小 距车侧边 Edge 值)(mm) (最大值)(mm)
(3) 最大 Max (4) 最小 Min
远光灯 Main Beam