交联聚乙烯绝缘阻燃电力电缆
- 1、下载文档前请自行甄别文档内容的完整性，平台不提供额外的编辑、内容补充、找答案等附加服务。
- 2、"仅部分预览"的文档,不可在线预览部分如存在完整性等问题,可反馈申请退款(可完整预览的文档不适用该条件!)。
- 3、如文档侵犯您的权益，请联系客服反馈,我们会尽快为您处理(人工客服工作时间：9:00-18:30)。
0.6/1kV 交联聚乙烯绝缘阻燃电力电缆
XLPE Insulated Flame-retardant Power Cable
一、产品标准Standard
本产品按GB12706-91《额定电压35kV及以下铜器芯、铝芯塑料绝缘电力电缆》、GB12666.5-90《电线电缆成束燃烧实验》、IEC60754《取自电缆或光缆的材料燃烧时释放出气体的试验方法》和IEC61034《电缆或光缆在特定条件下燃烧的烟密度测定》标准生产，同时还可根据用户需要按国际电工委员会推荐标准IEC、英国标准、德国标准及美国标准生产。
The product is manufactured according to the standard of GB12796-91 and GB12666.5-90 or IEC、BS、DIN and ICEA upon request. 二、适用范围Application
本产品适用于工频额定电压0.6/1kV及以下配电线路作配送电能之用。
The product is suitable for use in power distribution lines with rated power-frequency voltage up to and including
0.6/1kV.
三、使用特性Operating characteristics
·工频额定电压U0/U为0.6/1kV。
Rated power-frequency voltage U0/U为0.6/1kV.
·电缆导体的最高允许工作温度为90℃。
Max. permissible continuous operating temperature of conductor :90℃.
·短路时（最长持续时间不超过5S）电缆导体的最高温度不超过250℃。
Max. Short –circuit temperature of the conductor shall not exceed 250℃.
(5s maximum duration).
·电缆敷设时环境温度应不低于0℃。
The ambient temperature under installation should not below 0℃.
·电缆的阻燃性能符合GB12666.5-90标准A级或C级要求。
The flame retardant performance of cable is in according with A or C grade request of GB12666.5-90.
·低烟无卤电缆的无卤性能符合IEC60754《取自电缆或光缆的材料燃烧时释放出气体的试验方法》电缆燃烧时气体逸出试验。
The low smoke and non halo of cable is in according with IEC60754
成品电缆燃烧时绝缘和护套材料的PH值和电导率符合下表的规定。
When end product burning.PH value and conductivity of insulation and sheath material should suit infra –table
·低烟无卤电缆的低烟性能符合IEC61034《电缆或光缆在特定条件燃烧的烟密度测定》电缆燃烧烟密度试验。The low smoke and non halo of cable is in according with IEC61034
成品电缆燃烧时的最小透光率不小于30%。
When end product burning,the minimum light transmittance should not less than 30%.
·电缆弯曲半径不小于电缆外径15倍。
The bending radius of cable should not less than 15 times of the cable diameter.
四、电缆的型号、名称和使用范围Type Designation &Application of cable.
五、生产范围Production Range of nCable
*单芯铠装电缆仅用于直流系统，若用于交流系统，应采用非磁性材料铠装或隔磁措施。
*The single core armored cables are used for D.C Systenm only.As for A.C system,the magnetic isolation should be applied on the steel armor wires or non-magnetically materials should be used.
六、电缆结构尺寸及主要技术参数Construction and Main technical data
0.6/1KV单芯交联聚乙烯绝缘阻燃电力电缆
0.6/1kv Signie Core XLPE Insulated Flame – retardant Power Cable
注：#表示导体为紧压圆形
Where:# = compact circular standed conductor
0.6/1kv两芯交联聚乙烯绝缘阻燃电力电缆
0.6/1kv 2 Cores XLPE Insulated Flame –retardant Power
0.6/1kv两芯交联聚乙烯绝缘钢带铠装阻燃电力电缆
0.6/1kv 2 Cores XLPE Insulated Steel Tape Armoured Flame –retardant Power