静电滤油机操作流程

静电滤油机操作流程
英文回答：
Electrostatic Oil Purifier Operation Procedure.
1. Preparation.
Turn off the power supply and close the inlet and outlet valves.
Drain the dirty oil from the storage tank.
Remove the filter element and clean it thoroughly.
Install the cleaned filter element back into the machine.
Open the inlet and outlet valves.
Turn on the power supply.
2. Filling the Machine with Oil.
Slowly pour the oil into the storage tank until the oil level reaches the specified mark.
Close the oil filling port.
3. Filtration Process.
Set the desired operating parameters, such as voltage, current, and flow rate.
Start the filtration process.
Monitor the oil level and add oil as needed.
4. Discharge Process.
When the filtration process is complete, turn off the filtration pump.
Open the outlet valve to discharge the filtered oil.
Close the outlet valve when all the oil has been discharged.
5. Maintenance.
Clean the filter element regularly.
Check the oil level and add oil as needed.
Inspect the machine for any leaks or damage.
Cautions.
Do not operate the machine in a hazardous environment.
Do not use the machine to filter flammable or explosive liquids.
Wear appropriate personal protective equipment when operating the machine.
Keep the machine clean and free of debris.
中文回答：
静电滤油机操作流程。

1. 准备工作。

切断电源，关闭进、出油阀门。

将脏油从储油箱中放出。

取出滤芯并彻底清洗。

将清洗后的滤芯装回机器中。

打开进、出油阀门。

接通电源。

2. 灌装油。

将油缓慢倒入储油箱中，直至油位达到规定刻度。

关闭注油口。

3. 过滤过程。

设置所需的运行参数，如电压、电流、流量等。

启动过滤程序。

监测油位，视需要添加油。

4. 排油过程。

过滤过程结束后，关闭过滤泵。

打开出油阀以排放过滤后的油。

当所有油都被排出后关闭出油阀。

5. 维护。

定期清洗滤芯。

检查油位，视需要添加油。

检查机器是否有任何泄漏或损坏。

注意事项。

不要在危险环境中操作机器。

不要使用机器过滤易燃或爆炸性液体。

操作机器时佩戴适当的个人防护设备。

保持机器清洁，无杂物。