【宝马BMW】19306830-01 安全气囊灯亮

旗开得胜Measure no.

19306830-01

Subject

Air bag warning light on (sunroof variants only SA403)

安全气囊灯亮

Release date (mm/dd/yy)

8/26/08

Status

Approved

Organization

CN, CAR

Vehicles affected

E series

R55 R56

Engine

Body

Production period (from/to)

(mm/dd/yy)

/ 8/9/08

Comment on production period

since start of production

Feedback (all cases relating to

measure up to) (mm/dd/yy)

Complaint 投诉

Air bag warning light on.

1

Stored fault codes:

93B1: Head air bag driver's side or

93BO: Head air bag passenger's side

气囊灯亮

存储有以下故障记忆

93B1：驾驶员侧头气囊

93B0：乘客侧头气囊

Cause 原因

1. Loose connection or bent pin at connector X10864 or X10863 (head air bag connector)

2. Damaged head airbag wiring harness due to chafing on sharp edge of sunroof cross bracket

Affected car variant: SA403 Glass roof, electrical

1.连接松动或者线插X10864或X10863有针脚弯曲

2.头气囊线束被天窗支架尖锐部位损坏（受影响车辆：装配SA403 电子玻璃天窗）

Measure 措施

Do not replace any parts.

In the event of a customer complaint conduct the following repair instruction at the driver's or

passenger's side according to the stored fault code:

Step 1: Remove/lower headliner partially so that you can see the head air bag including connector (item1) and the wiring harness (item 2). See picture 01.

Step 2: Check if connector is loose or if a pin is bent. See picture 02. Re-secure connection.

1

Step 3: Check if wiring harness is damaged at the sharp edge of sunroof cross bracket (centre sunroof close to last harness clip). See picture 03 and 04 for position.

Step 4: Repair harness and add extra viscose fibre tape (BMW part no: 83 19 0 412 275) on harness and bracket rear edge. See picture 05.

不用更换任何零件：

如果有客户投诉执行下列维修指引：

第一步：部分拆开或降低头气囊饰板，可以看见头气囊连接插头和连接线束，参考图1

第二步：检查连接插头是否有松动和针脚有无弯曲，参考图2。重新安装好

第三步：检查线束是否有被天窗支架损坏，参考图3和图4.

第四步：维修好线束并且在天窗支架尖锐处贴上胶布（零件号：83190412275）

Fault

Fault location Nature of fault Condition

Safety/restraint and warning

systems, Airbags, Displays

Operates incorrectly, Display,

1