框胶MSDS

Date prepared: May/05/2008Date revised:M ATERIAL S AFETY D ATA S HEETManufacturerShiga-Minakuchi Plant, Sekisui Chemical Co., Ltd.1259 Izumi, Minakuchi-tyo Koka-City, Shiga Pref.Section in charge: Fine Chemicals Production Dept.Tel.: +81-(0)748-62-7110, Fax: +81-(0)748-62-9618Emergency Contact: Fine Chemicals Production Dept.Tel.: +81-(0)748-62-7110, Fax: +81-(0)748-62-9618Draw up : Shigeru Tanaka Belong : Q.A. Section. Fine Chemicals Production Dept. [Product] Photolec S-WB38(Trial product No. SUR-8D2)Product Description and IdentityNature of Composition: MixtureChemical Designation: Formulated compoundComponents[Composition] [Component Name] [Content] [ CAS No.]A Resin Acryl-Epoxy 60～80% Secret on businessB Hardener Amine 1～5% Secret on businessC Filler Silicate 10～30% Secret on businessD Additive Silane 1～5% Secret on businessAcryl particle 10～15% Secret on businessE Photo Initiator Acetophenone 1～5% Secret on businessTotal 100%Hazard ClassificationClass of hazard: Not applicable to the classification standard.Fire hazard: Combustible but not explosiveHealth hazard: It may cause rash of skin on contact.Environmental Effect: Effect of the product is not known.First AidWhen gets in eye: Immediately and thoroughly wash the eye with flowing waterand consult with an ophthalmologist.When clings to skin: Wash the compound off with water and soap.If inflammation takes place, seek a physician’s counsel.When inhaled: Gargle with water. If a person feels sick, put him/her to freshair and keep him/her in rest.When swallowed:Compel to drink much water and vomit(If necessary, consult a doctor)Fire Fighting ProcedureExtinguishing method: Eliminate the source of fire, and extinguish the fire usingappropriate agents, standing to the windward of fire. Extinguishing agents: Powder, Foam or Carbon Dioxide.Actions for Leak or SpillMethod of removal: Use waste rug and saw dust to remove the spilt product.and incinerate the recovery.Handling and Storage InstructionHandlingTake caution not to inhale. Wear long sleeve protective clothing, gloves(rubber), protective mask and glasses, to prevent contacting with skin or eyes.Provide air ventilation and UV-filtered lighting.StorageSuitable storage conditions:Store the product in good order in the pre-determined place.The product should be kept in a cool, dark place (under -10℃) in tightly closed containers, since it is reactive to light and heat.Mixed prohibition substanceAvoid mixture with strong oxidizer, strong Lewis base, strong inorganic acid, strong inorganic base(especially primary or secondary aliphatic amine).Prevention of Human Exposure to the ProductControl concentration: Not regulated.Permissible concentration: N ot known.Accommodation: Local exhaust devices and UV-filtered lighting for indoorworking space.Protective wears:For breathing: Dust mask .For hands: Gloves( rubber).For eyes: Protective glasses.For skin and body: Long sleeve working clothes (to prevent direct contact).Physical and Chemical PropertiesAppearance: Milky white high viscosity paste.Odor Few pungent smellSpecific gravity: 1.3Melting point: No data.Boiling point: No data.Solubility: No dataFire Hazard InformationFlash point: More than 240o C.Ignition point: Unknown.Explosion limit: Unknown.Ignition nature (self-ignition, Reaction with water): Not observedOxidation stability: StableReactivity: Reactive to heat and light.Health Hazard Information(Effect to human health including immunological effect.)Dermal erosion: Not known.Local effect: Possibly stimulative to eyes and skin when clung. Antigenicity: Not known.Acute toxicity: No dataSubacute toxicity: Not known.Chronic toxicity: Not known.Mutagenicity: (Chromosomal aberration to microbe) Not known. Genotoxicity: Not known.Teratogenicity: Not known.Miscellaneous:Health Hazard Information (for each material)1)Resin Acute toxicity: (Oral LD50/Rat,) >15.38g/Kg(Skin LD50/Rabbit,) >2g/Kg.Stimulation on eyes When it gets eyes, stimulus may continue forseveral days.Stimulation on skin When it adheres to the skin, it may turn red, or maycause to blister. In the most serious case, long timecontact may cause dermal erosion.2)Hardener Acute toxicity: (Oral LD50/Mouse,) >5000mg/KgLocal effect No stimulation for rabbit skin.Antigenicity Maximization test by Guinea pig result is positive.Specific Influence Recovery mutation test by microbe result is negative. 3)Filler Acute toxicity: No dataSpecial notes If it inhales so much for a long period of time, it willaccumulate in lungs. And classified into rank 3 for theUS Monograph (It can’t be classified aboutcarcinogenic)4)Additive Acute toxicity: No data(silane) Stimulative I t has strong stimulative for eyes. A blink becomesintense and tears come out.Contact on skin It is stimulative for skin. It makes unpleasant. It mayredden locally and cause swelling.Special notes When it swallowed, it reacts with gastric juiceintensely and methanol is generated.5)Photo Initiator N o dataEnvironmental Effect InformationCured resin will not be decomposed in water or in soil.Environmental Effect Information (for each material)1)Resin No data2)Hardener Ecological toxicity: 48Hr LC50 value for killifish and carp >1000mg/L3)Filler No data4)Additive Ecological toxicity: toxic for fish5)Photo Initiator No dataPrecaution for Waste DisposalIt can be treated like the earth-and-sand waste after incineration.Precaution for transportationCheck leakage and container damage before the transportation. Place on board in a way to prevent tumbling, dropping, damaging or collapse of load.UN Number: Not applicableUN class : Not applicableApplicable Laws (Japanese domestic Law)Fire Services Act : Not applicable.Labor Safety & Hygiene Law : Not applicable.PRTR Law: N ot applicable.MiscellaneousThe above fire hazard and health hazard information are not necessarily sufficient. However, customers should deal with this product carefully at their own risk, referring to this data sheet and taking careful consideration to the existing circumstances, when storing, handling or using it.The above mentioned physical/chemical property data are not intended for guarantee.。