AS60335-2-30-2004_A3-2007

AS/NZS 60335.2.30/AMD 3/2007-05-25 STANDARDS AUSTRALIA/STANDARDS NEW ZEALAND Amendment No. 3 to AS/NZS 60335.2.30:2004 Household and similar electrical appliances - Safety – Part 2.30: Particular requirements for room heaters REVISED TEXT The 2004 edition of AS/NZS 60335.2.30 is amended as follows; the amendments should be inserted in the appropriate places. SUMMARY: This amendment applies to Foreword, Clause 5 and 21 and Annex ZZ and Bibliography. Published on 25 May 2007 Approved for publication in Australia on behalf of the Council of Standards Australia on 3 May 2007. Approved for publication in New Zealand by the Standards Council of New Zealand on 30 March 2007. This amendment takes effect 6 months from the date of publication. FOREWORD Replace the first and second paragraph by the following: This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee EL-002 - Safety of Household and Similar Electrical Appliances and Small P ower Transformers to supersede AS/NZS 3350.2.30:2007, on 31 May 2011. During the interim period either AS/NZS 3350.2.30:2007 or AS/NZS 60335.2.30:2004 may be used for regulatory purposes in both Australia and New Zealand. This Standard incorporates Amendment No. 1 (June 2005), Amendment No. 2 (November 2005) and Amendment No. 3 (May 2007). The changes required by the amendments are indicated in the text by a marginal bar and amendment number against the clause, note, table, figure or part thereof affected. Where an application date other than immediate is applicable to an amendment, the date of application (DOA) is indicated by the marginal bar against the part affected. 5 Gener a l conditions for the tests 5.2 Add the following to the addition:
NOTE 301 The test of 21.301 is carried out on a separate appliance.
s e d b y U N I V F S O U T H A U S T R A L I A o n 22 A p r 2008
21 Mechanical Strength
21.1 Replace the first paragraph by the following; DOA 25/11/07 DOA
25/11/07Compliance is also checked by the tests of 21.101 and 21.102.
Compliance is also checked by the tests of 21.101, 21.102 and 21.301.
Add the following new subclause. 21.301 Portable fan heaters having a substantially non-metallic enclosure are subjected to the free fall test, procedure 1, of IEC 60068-2-32. The test is carried out on a new sample. The appliance is dropped vertically onto its base from a height of 500 mm. After the test, the requirements of 8.1, 16.3 and 19.113 shall be met.
Th e test is not applicable to fan heaters th at are also intended to be operated at maximum heat output, with the fan switched off.
Annex ZZ
DOA
25/11/07 DOA
25/11/07 5.2Before the variation for 7.1, insert the following variation:
5.2 After Note 101 insert the following variation:
NOTE 301 The test of 21.301 is carried out on a separate appliance.
21.1 After the variation for 11.8, insert the following variations:
21.1Replace the first paragraph with the following variation:
Compliance is also checked by the tests of 21.101, 21.102 and 21.301.
21.301 Portable fan heaters having a substantially non-metallic enclosure
are subjected to the free fall test, procedure 1, of IEC 60068-2-32. The test
is carried out on a new sample.
The appliance is dropped vertically onto its base from a height of 500 mm.
After the test, the requirements of 8.1, 16.3 and 19.113 shall be met.
Th e test is not applicable to fan heaters th at are also intended to be
operated at maximum heat output, with the fan switched off.
Bibliography Replace AS/NZS 3350.2.40, AS/NZS 3350.2.53 and AS/NZS 3350.2.81 by AS/NZS 60335.2.40, AS/NZS 60335.2.53 and AS/NZS 60335.2.81 respectively.
s e d b y U N I V E R S I T Y O F S O U T H A U S T R A L I A o n 22 A p r 2008
This page has been left intentionally blank.
s e d b y U N I V E R S I T Y O F S O U T H A U S T R A L I A o n 22 A p r 2008。