203、海外项目英语口语(文本+MP3)：HSE Orientation Training 入场安全培训3

203、HSE Orientation Training

入场安全培训3

1、文本（英文）

Any employee whose work has them out site in area that is not protected by permanent or temporary guardrails or on any other surface such as structural steel, steps or landings where there is subject to fall greater than 6 feet must be protected by personal fall protection system, the three types of personal fall protection system are: personal fall arrestor, positioning devices and personal restraint system. At times, AEGO performs work from elevated platforms where fall hazards exist; this will typically require a personal fall arrest system for fall protection. A personal fall arrest system is used to stop employee’s fall from elevated working level, the system consist of an anchorage, connectors, full body harness, and a lanyard with a deceleration device. Self-retracting lifelines or vertical lifeline with a rope grab can be used in lieu of the 6 feet lanyard with a deceleration device. Anchor point used as a personal fall arrest system should be secured at or above the level of the back D-ring on the harness, this actually ensure that free fall distance is limited, the anchor point must be a structural member capable supporting a minimum

weight of 5000 pounds per employee, the supervisor must ensure that all personnel is in a personal fall arrest system are properly trained, for all AEGO drilling operations, there are special falling protection guidelines that has been set in place, to begin, these requirements specify that 20 to 25 feet barrier must be set up around the bull hole before any drilling starts, this barrier can be made up of caution tape or fencing when available, before any drilling activity begins, you are required to be in a fall protection harness, and this harness have safety line connected to the anchor, before you are allowed to cross the barrier. In addition, the safety line must set to allow you no closer than within 2 feet of bull hole, if you are new to the drilling operations, or have any questions, you supervisor will walk you through the procedure when you are on site.it is essential to the safety of everyone, that every piece of fall protection equipment be inspected and maintained on a regular basis, each fall protection system component must be inspected prior to use, check for wear, tears, mold, mildew, or distortion, ensure that no straps are cut, torn. Check for worn stitching, inspect hardware for cracks, sharp edges or burns, ensure that slap pokes close and lock tightly, check for distorted hooks, and that all buckles work properly, defected