表面处理检测报告

Coating
3M胶带检测结果 Inspection results on 3M tape
Thickness requirement of painting is min. 80um
proof plate
检测结果判断 Inspection results: 结论 Comments:
检验 Inspected by
the intersectons of the cross-cut area ,no more Thickness
than 5% is affected.
gauge
3.4B级以下不可接受
Classes lower than 4B are not acceptable
4.涂层样板
4.喷粉厚度要求最小80μm
备注 Remarks
50°±5° 备注
Remarks
日期 Date 日期 Date t
Surface treatment inspection report (Cross-cut test) 表面处理检测报告 (百格测试)
产品名称 PartName 产品编号 Part No. 版本号Drawing Rev.
到货日期 Arrival Date 检验日期 Inspect Date 样本数量 Sample Qty.
2.3M胶带
附着力
2.4B级：切口的相交处有小片剥落，划格 3M tape
Adhere panes firmly with 3M tape,then pull apart tape 区内实际破损≤5%
quickly,inspect painting quality by checking how much 4B Classes: Only small flakes of the coating at 3.膜厚仪
Color deviation
coating is flaked off on panes area and get the results 3.用膜厚仪检测涂层厚度
Use thickness gauge to inspect thickness of coating 4.色差比对
Color deviation inspection
处理工艺 பைடு நூலகம்rocess
测试标准 Test stardand
GB/T9286-98
室温 Room temperature
21°±2°
相对湿度 Relative humidity
50°±5°
项目 Items
外观 Appearance
厚度 Thickness
检测方法 Test method
技术要求 Technical requirements
工具 Tools
1.用百格刀在涂层表面用力画下100片小方格 Use Cross-cut tester to draw 100 panes on coating
1.5B级：百格边缘基本完好，没有涂层从 1.百格刀
方格脱落
Cross-cut
产品表面检测结果 Inspection results on product
色差
surface;
5B Classes:The edges of the cuts are
tester
2.将3M胶带牢固地粘在方格上，然后迅速拉起3M胶 completely smooth,no coating was flaked off
带，通过检测方格上涂层脱落的面积来做判定涂层 from panes
职责 Title
邮箱 Email
日期 Date
客户验证 Verified by Customer 评估 Evaluated by 批准Approved
职责 Title 拒收 Failed
邮箱 Email 有条件接受 Approved with deviation
日期 Date 重新送样 Resubmit