DELL机架式服务器导轨安装图释

Server Depth w/ CMA Rail Compressed Rail Extended

1950 Sliding Rapid \ VersaRail26.98 inch29.5 inch

2950 Sliding Rapid \ VersaRail26.84 inch29.46 inch

Rail Conversion

The following procedure outlines converting the 9th generation PowerEdge rails from RapidRails to VersaRails. Converting from VersaRails to RapidRails follows the same procedure.

NOTE:

The rail in the example is a PowerEdge 1950 rail. The PowerEdge 2950 rails follow the exact same conversion process.

9th Generation Rail Conversion

Locate the rail conversion bracket on the end of the rail.

1

.

2.Lift the release lever on the rotating mounting bracket.

3.Rotate the bracket counter clock wise.

4.Lift the bracket and rotate it 180 degrees counter clock wise.

5.Line the bracket up with the two posts and set it down.

6.Rotate the bracket clock wise until it snaps into place.

Racking

The following procedure outlines the process of racking the PowerEdge 2950 using the new 9th generation PowerEdge rails.

Racking the PowerEdge 2950

1 .Push the front slide assembly mounting hook into the square hole on the vertical rail.

2.Push the rear slide assembly mounting hook into the square hole

on the vertical rail.

3.Repeat steps 1 and 2 for the slide assembly on the other side.

4.Extend the inner member rails out of the rack.

5.Align the server's shoulder nuts with the rail's J-slots.

6.Lower the server into the rails making sure the all shoulder nuts

slide into the rail j-slots.

7.Gently push the server towards the back of the rack to engage

the j-slot locking levers.

8.Press the slide-release latch on the outside of each inner slide.

9.Push the server towards the back of the rack.

10.Tighten the ear nuts to secure the server to the rack.