有机硅锌粉底漆简述

合集下载
  1. 1、下载文档前请自行甄别文档内容的完整性,平台不提供额外的编辑、内容补充、找答案等附加服务。
  2. 2、"仅部分预览"的文档,不可在线预览部分如存在完整性等问题,可反馈申请退款(可完整预览的文档不适用该条件!)。
  3. 3、如文档侵犯您的权益,请联系客服反馈,我们会尽快为您处理(人工客服工作时间:9:00-18:30)。

Storageand Handling 贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处
Pack size 包装规格 A;30Kg in 20 liter container 甲:30公斤装于20公升容器中 B:90g in a litter bottle 乙:90克装于一小瓶中
Flash Point 闪点 35℃
Specific Gravity 比重Approx 2.12Kg/L 大约2.12公斤/公升
Intended Uses
用途一种灰色漆,用于温度150℃-500℃(如发动机、锅炉、废弃管道等做底漆)
A Grey coating to protection at temperature between 150℃ and 500℃, It is suited for motor, boiler and exhaust gas pipeline etc, as primer.
Product
Information
产品简介
Two packages, Silicone zinc dust paint 双罐装,锌粉有机硅树脂漆
Application details 产品数据V olume Solids 固体份≥62.5%
Dry Flm Thickness干膜厚度30-40microns 30-40微米Theoretical Coverage 理论涂布率7.37-9.08m2 /Kg 7.37-9.08平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗
Storage and Handling 施工详述Mix Radio 混合比 A : B=100:0.3(by weight) 甲:乙=100:0.3(重量比)
Method of Application 施工方法
Airless Spray 无空气喷涂 Recommended 推荐采用
Brush or Roller 涂刷或辊涂 Recommended 推荐采用
Conwentional Spray 传统喷涂 Not Recommended 不推荐采用
Thinner 稀释剂 C002
Cleaner 油漆设备清洗剂 C002
Pot Life 使用期 Not limit 不限制
Storage 贮存期 Six months 六个月
Drying time
干燥时间
Substrate
Temperature
底材温度
Touch Dry
表干
(h)
Hard Dry
硬干
(h)
Over coating Interval
覆涂间隔
Mix最短Max最长
5℃
23℃
35℃
18
6
5
72
24
24
24 hours 小时
24 hours 小时
24 hours小时
14days (天) 有机硅锌粉底漆简述
Specification and Surface preparation 技术要求及表面处理Substrate should be blasted or rust-removed manually to near white
Clean the surface with cleaner There is no dirt (such as greasy dirt, grease and salts etc) on the surface, The surface to be applied must be clean and dry
底材喷砂处理或手工除锈近乎出白
用清洁剂清理表面,无污物(如油污、油脂、盐类等)
在施工前应保证表面清洁干燥。

Limitations 限制Recommended coat: With high-pressure airless spray paint, one coat with 30-40 microns of dry film 推荐道数:高压无空气喷涂,涂装一道,干膜厚度达30-40微米。

Safety Precautions 安全措施This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
This product is a kind of solvent-based paint .Inorder to avoid danger or accident, minimal safety precautions,as follow , should be down .
The paint contains volatile solvent and is flammable . So must keep away from sparks and open flames.No smoking at applacation site ,Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid producting sparks .Flash point of paint , mentioned above on product Data sheet, is the lowest temperature at which mixture of the volatile materails of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general, Therefore, 200m3 of ventilation quantuty per 1Kg solvent (according to the solvent ) is necessary.
Product skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves,eye protection, face masks barrier cream and so on ). Kif paint gets in touch with skin , wass fully with large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions(Refer to the specfications), our company will NOTbe responsible for any accident.
本产品由专业人缘在工业场所使用,使用时请参照本说明书及健康安全手册,如客户在使用本产品前,未能仔细了解有关产品的健康安全知识,请与本公司联系.
该涂料为溶剂型涂料,为避免事故或危险发生,应采取最低限度的安全措施如下:
此涂料为易燃物,并含有挥发性易燃溶剂,,故必须远离火星和明火,严禁在作业场所吸烟,并采取有效措施,防止火星产生(如采用防爆电器设备,杜绝静电积累,避免金属撞击等)本产品说明书中所列涂料及溶剂的闪点是引起燃烧的最低温度. 施工场所应尽量进行通风良好,为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10%,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10%的工作环境.
采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服,手套,护目镜,面罩及涂防护油等)如产品不慎接触到皮肤,应用温水及肥皂或适当的工业清洁剂彻底清洗,如眼睛受到污染,用清水冲洗至少10分钟,并立即就医.
建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,尤其在通风不良环境下施工时,细心处理旧漆桶以免污染环境.
责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任.
来源。

相关文档
最新文档