书本自动打包机设计

摘要

图书的需求迅速增加，特别是在春、秋两季入学，将迎来高峰。同时，“用工荒”问题日益严重，传统的手工包装方法很难满足要求。为了适应这一形势，本文开发了一个图书自动包装机，提高图书的包装效率，减少了操作人员的劳动强度。

本文首先讨论了打包机的国内外现状，然后根据书籍打包机的设计要求，进行对本包装机的机械结构设计，详细介绍了机器的一部分的设计机制，该机制原理图给出关键部分的功能，原理图描述。本书对包装机械机构和控制系统的设计，进行了改善和优化结构。

关键词：图书，书本打包机，机械结构，机构原理

Abstract

Books demand increased rapidly, especially in the spring and autumn season two entrance, will usher in the peak. At the same time, "labor shortage" problem is more and more serious, the traditional manual packing methods are difficult to meet the requirements of. In order to adapt to this situation, this paper developed an automatic book packing machine, to improve the efficiency of book packaging, reduce the labor intensity of the operator.

This paper first discusses the status quo of machine at home and abroad books packed, then according to the requirement of design books balers, carries on the design to the book packing machine mechanical structure, introduces in detail the mechanism of part design of the machine, the key part of the mechanism principle diagram is given, the schematic diagram of the function were described. The design of the book packing machine mechanism and control system, the structure of the improvement and optimization.

Key Words:Books, books balers, mechanical structure, mechanism

目录

摘要 ......................................................................................................................................... I Abstract...................................................................................................................................... II 目录 ...................................................................................................................................... III 第1章绪论 (1)

1.1引言 (1)

1.2 国内外研究现状与发展 (1)

1.2.1国外研究现状 (1)

1.2.2 国内发展现状 (3)

1.3 本文研究内容 (4)

第2章书本打包机总体设计 (5)

2.1主要技术要求 (5)

2.2书本打包机总体工艺设计 (5)

2.3机械结构功能分解与分析 (6)

2.4 本章小结 ..................................................................................... 错误!未定义书签。第3章本章标题 .......................................................................................错误!未定义书签。

3.1机构功能要求 .............................................................................. 错误!未定义书签。

3.2运动机构的选择 .......................................................................... 错误!未定义书签。

3.3槽型凸轮设计 .............................................................................. 错误!未定义书签。

3.4齿轮齿条设计 .............................................................................. 错误!未定义书签。

3.4.1几何尺寸计算 ................................................................... 错误!未定义书签。

3.4.2重合度校核 ....................................................................... 错误!未定义书签。

3.4.3齿轮强度校核 ................................................................... 错误!未定义书签。

3.5轴的设计 ...................................................................................... 错误!未定义书签。

3.5.1确定最小轴径 ................................................................... 错误!未定义书签。

3.5.2轴的校核 ........................................................................... 错误!未定义书签。

3.5连杆的设计 .................................................................................. 错误!未定义书签。第4章打包机其他机构设计 ...................................................................错误!未定义书签。