CE法规要求

Note 燈具通則
EN 60968
Self-ballast lamps for general lighting services_ safety requirement
燈泡/燈管
EN 62031
Self Ballasted LED modules
LED module
Safety
Lamp controlgear – EN 61347-1 Part 1: General and safety requirements EN 61347-2-13 Part 2-13: Particular requirements for
EN 62031 13
Fault conditions
IEC 61347-1(Driver 要求) 結構材質要求:
15
Construction
Wood, cotton, silk, paper and similar fibrous
material shall not be used as insulation.
similar application
Particular requirementsEN 60598-2-20
Section 20: Lighting chains
燈串
EN 60598-2-23
Particular requirementsSection 23: Extra low voltage lighting system for filament lamps
2
(5) CS (Conducted Susceptibility ) (傳導雜訊耐受) (6) PFMF (Power Frequency Magnetic Field ) (電源頻率磁場) (7) DIP (Voltage dip) (電壓瞬降)
Table 3. Emission Requirements
Driver IEC 61347-13:14 (Abnormal
operations and fault conditions test) 若 Driver outside,則燈板本身也要測試
4
5,6,8,9 Common modifications(Input test) 測量功率(W)/電壓(V)/電流(A)
Statement
EN 61000-4-2 ESD (靜電放電)
EN 61000-4-3 RS (射頻雜訊耐受) EN 61000-4-4 EFT (電性快速叢波脈衝) EN 61000-4-5 Surge (雷擊) EN 61000-4-6 CS (傳導雜訊耐受) EN 61000-4-8 PFMF (電源頻率磁場) EN 61000-4-11 DIP (電壓瞬降)
證,大多國家可用 CB 的方式再轉為其認證,僅少數機構 (ex: TUV-SUD…)可 發證，規費費用較高．
Table 1. Introduction of Principle Standards
Category Standard EN 60598-1
Title of Standard General requirements and tests
3
Safety 要求
EN 60968 + EN 62031 (or IEC 62560)
EN 60968
Clause 4 5
Requirement Markings(標示) Interchangeability(互換性)
6
Protection against electric shock
Note 基本要求: Brand name/型號/電性 EN 60061-3, EN60061-3(Lamp 系列) 1. Test finger(10N)不能碰觸帶電部件,內部 金屬部件,基本絕緣的金屬 2. 燈頭旋入標準燈座後,燈頭的帶電部位 不得被觸及
使用白熾燈之超低 電壓燈具系統
4. EMC(電磁相容) = Emission(電磁放射) + Immunity(電磁耐受) A. Emission(電磁放射)(參見 Table 3.): (1) EMI(電磁干擾): EN55015 (2) Current harmonics(電流諧波): EN 61000-3-2 (3) Voltage flicker(電壓閃爍變動): EN61000-3-3 B. Immunity(電磁耐受)(參見 Table 4.) (1) ESD (Electrostatic discharge) (靜電放電) (2) RS (Radiated Susceptibility) (射頻雜訊耐受) (3) EFT (電性快速叢波脈衝) (4) Surge (雷擊)
Standard EN 55015
Statement Radiated Emission (RE) (輻射干擾) 1. 三軸環形天線 2. Open Site
Conducted Emission ( CE ) (傳導干擾) :
Harmonic current emissions EN 61000-3-2 (Current Harmonics) (電流諧波)
Resistance to flame and ignition(防 sec 後移開後, 樣品上之任何燃燒火焰需在
11
火與耐燃)
30 sec 內熄滅, 所有燃燒下落物不可點燃樣
品下方距離 200 mm±5mm 之薄紙
不得起火或產生易燃氣體,且帶電部件不可 變為可觸及
12
Fault conditions(故障狀態)
8
試)
1. B22d/ E265 Nm
9
Cap temperature rise
1. 在額定電壓或電壓範圍之最大值下測試 2. 溫升不得超過 120K(for E14, E27)
1. Retaining live part in position: 125℃ or
距離要求 IEC 60598-1
16
Creepage distances and clearances 請見 Table A, A1, A2, A3, A4
CE 認證基本主法規要求(請見 Table 1.) 1. 完整 CE-Mark 需完成以下認證
A. LVD/ EMC/ R& TTE 指令(無線電和電信終端設備的指令) B. EuP/ ErP, Energy Label C. RoHS, REACH, WEEE
2. 分成 Safety(需包含 EN62471 獨立報告) + EMC Safety report 可以 LVD report 或 CB report 的方式出具,CB 為國際認可轉
EN 61547
Equipment for general lighting purposesEMS
EMC Immunity Requirements
3. Safety Report 主法規說明如下: A. 燈源(球泡燈,PAR 燈,燈管…等): EN 60968 + EN 62031 (目前亦可用 IEC62560,但此法規尚未能出具 CB Report) B. 燈具(平板燈,筒燈…等): EN 60598-1 或 EN 60598-2(但若分屬不同的 燈具類別,則主法規會從 EN60598 Part2 中細分,請見 Table 2.) C. 若 Driver outside 之燈源/具,則需獨立出具 EN 61347 之報告
25℃+T
Resistance to heat (耐熱性)(球壓 2. Protection against electronic shock: 80℃
10
測試, ball-pressure test)
ot 25℃+T
3. 放置烘箱 1 hrs
4. Impression ≦ 2mm
Glow wire 650℃, 樣品放置 Glow wire 上 30
探照燈
EN 60598-2-6
Particular requirementsSection 6: Luminaires with built-in transformer for filament lamps
內含鎢絲燈泡用變 壓器之燈具
Particular requirementsEN 60598-2-7
1
Table 2. Category of Luminaire Requirements
Standard
Title of Standard
Applied Luminaires
Particular requirements EN 60598-2-1
Section 1-Fixed general purpose luminaires
固定式燈具(例如: 壁燈, 吸頂燈)
Particular requirementsEN 60598-2-2
Section 2: Recessed luminaires
嵌燈
Particular requirementsEN 60598-2-3
街燈, 路燈
Section 3: Luminaires for road and street lighting
Section 7: Portable luminaires for garden use
可攜式花園燈
Particular requirementsEN 60598-2-11
Section 11: Aquarium luminaires
水族燈
Particular requirementsEN 60598-2-18 Section 18: Luminaires for swimming-pool and 游泳池燈
Conditions Contact: ± 4kV Air: ± 8kV 80 MHz~1000 MHz 3V/m 1 kV peak, 5 kHz <25W L-L: 0.5kV, L-G: 1kV >25W L-L: 1kV, L-G: 2kV 3 Vr.m.s., 0.15MHz~80MHz 3 A/m, 50/60 Hz 70%, 10 periods 0%, 0.5 periods
Voltage Fluctuations & Flicker EN 61000-3-3 (輸出電壓變動和閃爍)
Conditions
1. 9kHz~30MHz 2. 30Mz~300MHz 9kHz~30MHz <25W 不需測試
N/A
Table 4. Immunity Requirements
Standard
radio disturbance
EN 61000-3-2 Limits for harmonic current emissions Harmonic
EMC EN 61000-3-3 Limitation of voltage changes, voltage Flicker
fluctuations and flicker
Driver 評估
d.c. or a.c. supplied electronic
controlgear for LED modules
EN 62471
Photobiological Safety of lamps and lamp system
光傷害
EN 55015
Limits and methods of measurement of EMI
3. 外部金屬不得意外放電
1.絕緣阻抗: 500Vdc, 1 min 燈頭載流部位
及可碰觸部位間之阻抗需≧4Ω
Insulation resistance(絕緣阻抗) and electric strength(耐電壓,
2.耐電壓(1 min):
7
A. Type HV(220~250): 4000 Vrms
withstand voltage) after humidity
(吸溼性)treatment
B. Type LV(100~120): 2U+1000 V 3.吸溼性: 溼度 91~91%, 溫度 20~30℃, 48
hrs
Lamp: Torque 測試
Mechanical strength(機械強度測 (成品或有機構外殼需要測試)
Particular requirementsEN 60598-2-4
Section 4: Portable general purpose luminaires
可攜式燈具(例如: 桌燈, 落地燈)
Particular requirementsEN 60598-2-5
Section 5: Floodlights