BA121S01-100(12.1)

Specification
For
CONTENT LIST
Record of Revisions
1.1 Introduction
is a color active matrix TFT-LCD Panel using amorphous silicon TFT's BA121S01-100
0.5t Glass (Single)
Thin and light weight
High luminance and contrast ratio, low reflection and wide viewing angle
Parameter Specification Active Area 246.0(H) × 184.5(V) Number of Pixels 800(H) RGB × 600(V)
2. The TFT and CF Rubbing Direction;
2.1 Absolute Maximum Ratings
The absolute maximum ratings are list on table as follows. When used out of the
Item Symbol Supply voltage VDD CMOS/TTL input voltage Vin
Gate IC---HX8677-G Tcon IC---HX8841
Parameter Symbol Min
LED Forward Voltage V F 27 2.5 Block Diagram
Power on Sequence
20Pin data connector
5Pin B/L power connector Remark: PWM frequency 120~1Khz
5.1 Overview
The test of Optical specifications shall be measured in a dark room(ambient luminance
pixels displaying white. This measurement shall be taken at the locations shown in FIG. 2.
4. Uniformity measurement shall be taken at the locations shown in FIG. 2&3, for a total of the measurements per display, measure surface luminance of these nine points across the LCD surface
Figure 1. The definition of Vth & Vsat
Figure 2. Measurement Set Up
(L = 50cm)
6.1 Dimension Requirements for LCD Part
Mechanical outlines for the panel (H: horizontal length, V: Vertical length
TBD
Item Specification MDL Model BA121S01-100 1 PE Bag Material Thickness
A 121S01-100
10.1 Mounting Method
The panel of the LCM consists of two thin glasses with polarizer which easily get damaged.
The LCM use C-MOS LSI drivers, so customers are recommended that any unused input terminal would be connected to Vdd or Vss, do not input any signals before power is turn on, and ground you body, work/assembly area, assembly equipments to protect against static
A slight dew depositing on terminals is a cause for electro-chemical reaction resulting in terminal open circuit. Relative humidity of the environment should therefore be kept below 60%RH.。